Not that I know of.
We put up our first PTP450 link last week; an 8.9 mile shot using 28 dBi
panels from MTI. I "eyeballed" the link master, then tuned in the link
slave a couple days later. Signal is coming in at -57 to -58, and
typically running at 8x/8X (have tx power set to 17 dBm at both ends).
Went back today to fine tune the link master, but only got another 1/2
dBm out of it; I could have stayed home.
Aggregate throughput is in the 90-95 Mbps range.
bp
On 10/21/2014 9:22 AM, Craig House via Af wrote:
We have put up our first pair of backhaul 450 radios today 5.5 mile wink
signal before was a -51 on both ends dishes did not get repointed just replace
the radios
The radio see each other at a -59 signal but they will not connect up says that
the BER is too high
This is from a water tower to a 600 foot communications tower that is easy line
of sight from 40 feet lower on each end
Is there a special trick to making these radios connect?
Sent from my iPhone
