What are you asking? The connectorized 450 radios have a special cap
with the two-level knockouts. Like the 900 caps, but both sides have the
knockout.
I wish Cambium would just make all the caps like that for all the
radios. Stuff gets swapped around and misplaced in trucks too often.
On 10/21/2014 6:19 PM, Matt via Af wrote:
We put up our first PTP450 link last week; an 8.9 mile shot using 28 dBi
panels from MTI. I "eyeballed" the link master, then tuned in the link
slave a couple days later. Signal is coming in at -57 to -58, and typically
running at 8x/8X (have tx power set to 17 dBm at both ends). Went back
today to fine tune the link master, but only got another 1/2 dBm out of it;
I could have stayed home.
How does that work with two RF pigtails and one cat5 coming out bottom
of Canopy case? Then add another cable for timing since there is no
sync over power option.
