+1 John Woodfield Delmarva WiFi http://www.delmarvawifi.com cell (410) 708-1937
-----Original Message----- From: "Rory Conaway" <[email protected]> Sent: Friday, January 30, 2015 4:26pm To: "[email protected]" <[email protected]> Subject: Re: [AFMUG] Mounting to 4" Square tubing The nice part is you can get this from Home Depot and it’s cheap. rory From: Af [mailto:[email protected]] On Behalf Of Rory Conaway Sent: Friday, January 30, 2015 2:25 PM To: [email protected] Subject: Re: [AFMUG] Mounting to 4" Square tubing No welding. Put channel bars on either side of the 4” bar perpendicularly. User some all-thread to compress them against the bar. Just use the bar clamps for the channel bad. Rory From: Af [[ mailto:[email protected] ]( mailto:[email protected] )] On Behalf Of TJ Trout Sent: Friday, January 30, 2015 2:11 PM To: [ [email protected] ]( mailto:[email protected] ) Subject: Re: [AFMUG] Mounting to 4" Square tubing Like welding you mean rory? On Fri, Jan 30, 2015 at 1:09 PM, That One Guy <[ [email protected] ]( mailto:[email protected] )> wrote: upc1 and upc2 from sitepro On Fri, Jan 30, 2015 at 2:56 PM, Rory Conaway <[ [email protected] ]( mailto:[email protected] )> wrote: Use channel bar to create a frame around the tubing and then attach the pole to that. Rory From: Af [mailto:[ [email protected] ]( mailto:[email protected] )] On Behalf Of TJ Trout Sent: Friday, January 30, 2015 1:52 PM To: [ [email protected] ]( mailto:[email protected] ) Subject: [AFMUG] Mounting to 4" Square tubing Any ideas on mounting sectors and backhauls to 4" sqare tubing? -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
