Gotcha. So basically a home made pipe to pipe clamp? On Jan 30, 2015 1:31 PM, "Rory Conaway" <[email protected]> wrote:
> In a pinch, we even use this for 12” poles. Little different setup but > works great. > > > > Rory > > > > *From:* Af [mailto:[email protected]] *On Behalf Of *John Woodfield > *Sent:* Friday, January 30, 2015 2:29 PM > *To:* [email protected] > *Subject:* Re: [AFMUG] Mounting to 4" Square tubing > > > > +1 > > John Woodfield Delmarva WiFi http://www.delmarvawifi.com cell (410) > 708-1937 > > > > -----Original Message----- > From: "Rory Conaway" <[email protected]> > Sent: Friday, January 30, 2015 4:26pm > To: "[email protected]" <[email protected]> > Subject: Re: [AFMUG] Mounting to 4" Square tubing > > The nice part is you can get this from Home Depot and it’s cheap. > > > > rory > > > > *From:* Af [mailto:[email protected] <[email protected]>] *On > Behalf Of *Rory Conaway > *Sent:* Friday, January 30, 2015 2:25 PM > *To:* [email protected] > *Subject:* Re: [AFMUG] Mounting to 4" Square tubing > > > > No welding. Put channel bars on either side of the 4” bar > perpendicularly. User some all-thread to compress them against the bar. > Just use the bar clamps for the channel bad. > > > > Rory > > > > *From:* Af [*mailto:[email protected]* <[email protected]>] *On > Behalf Of *TJ Trout > *Sent:* Friday, January 30, 2015 2:11 PM > *To:* *[email protected]* <[email protected]> > *Subject:* Re: [AFMUG] Mounting to 4" Square tubing > > > > Like welding you mean rory? > > > > On Fri, Jan 30, 2015 at 1:09 PM, That One Guy <*[email protected]* > <[email protected]>> wrote: > > upc1 and upc2 from sitepro > > > > On Fri, Jan 30, 2015 at 2:56 PM, Rory Conaway <*[email protected]* > <[email protected]>> wrote: > > Use channel bar to create a frame around the tubing and then attach the > pole to that. > > > > Rory > > > > *From:* Af [mailto:*[email protected]* <[email protected]>] *On > Behalf Of *TJ Trout > *Sent:* Friday, January 30, 2015 1:52 PM > *To:* *[email protected]* <[email protected]> > *Subject:* [AFMUG] Mounting to 4" Square tubing > > > > Any ideas on mounting sectors and backhauls to 4" sqare tubing? > > > > > > -- > > All parts should go together without forcing. You must remember that the > parts you are reassembling were disassembled by you. Therefore, if you > can't get them together again, there must be a reason. By all means, do not > use a hammer. -- IBM maintenance manual, 1925 > > >
