If you say so. John Woodfield Delmarva WiFi http://www.delmarvawifi.com cell (410) 708-1937
-----Original Message----- From: "Mathew Howard" <[email protected]> Sent: Saturday, February 14, 2015 11:29am To: "af" <[email protected]> Subject: Re: [AFMUG] Trango Altum AC PTP test results I have both of our AF5 links running in full duplex mode now, but I have played around with TDD on them, and as I recall, latency was 2-3ms. On Sat, Feb 14, 2015 at 7:54 AM, Mike Hammett <[ [email protected] ]( mailto:[email protected] )> wrote: It would be the same as any of the existing AFs in TDD mode. I saw some reports that it was in the 2 ms area (IIRC). There are some people on the list and some you know (not me) that have been using the AF5x. ----- Mike Hammett Intelligent Computing Solutions [ http://www.ics-il.com ]( http://www.ics-il.com ) From: "Erich Kaiser" <[ [email protected] ]( mailto:[email protected] )> To: [ [email protected] ]( mailto:[email protected] ) Sent: Saturday, February 14, 2015 7:44:08 AM Subject: Re: [AFMUG] Trango Altum AC PTP test results I would assume AF5x is going to be the same issue if you are using GPS? Erich Kaiser North Central Tower Consulting [ [email protected] ]( mailto:[email protected] ) Office: [ 630-621-4804 ]( tel:630-621-4804 ) Cell: [ 630-777-9291 ]( tel:630-777-9291 ) On Fri, Feb 13, 2015 at 10:23 PM, Kurt Fankhauser <[ [email protected] ]( mailto:[email protected] )> wrote: I can't afford 8-12ms of latency 7 hops out... Time for some Full Duplex links I suppose.... Kurt Fankhauser Wavelinc Communications P.O. Box 126 Bucyrus, OH 44820 [ http://www.wavelinc.com ]( http://www.wavelinc.com/ ) tel. [ 419-562-6405 ]( tel:419-562-6405 ) fax. [ 419-617-0110 ]( tel:419-617-0110 ) On Fri, Feb 13, 2015 at 10:43 PM, Erich Kaiser <[ [email protected] ]( mailto:[email protected] )> wrote: The Mimosa seems awesome so far (Except for lack of SNMP support, which is coming in April). If you have GPS sync it seems to run between 8ms-12ms. Erich Kaiser North Central Tower Consulting [ [email protected] ]( mailto:[email protected] ) Office: [ 630-621-4804 ]( tel:630-621-4804 ) Cell: [ 630-777-9291 ]( tel:630-777-9291 ) On Fri, Feb 13, 2015 at 9:29 PM, Kurt Fankhauser <[ [email protected] ]( mailto:[email protected] )> wrote: I was hoping to replace a Ligowave link I have that's running on 40mhz. I don't feel like burning up a whole 80mhz of spectrum through, so I think I'll be buying a PTP-650 especially since I need DFS freq's. Kurt Fankhauser Wavelinc Communications P.O. Box 126 Bucyrus, OH 44820 [ http://www.wavelinc.com ]( http://www.wavelinc.com/ ) tel. [ 419-562-6405 ]( tel:419-562-6405 ) fax. [ 419-617-0110 ]( tel:419-617-0110 ) On Fri, Feb 13, 2015 at 10:19 PM, Jeremy <[ [email protected] ]( mailto:[email protected] )> wrote: I see that they sell them on the 'Trango store' now too. Pretty sweet. On Fri, Feb 13, 2015 at 8:17 PM, Jeremy <[ [email protected] ]( mailto:[email protected] )> wrote: Yeah, that is what I was told at Animal Farm also. It seems like doing something specific or something in the wrong order makes them not work. Next time I guess I'll have to follow directions, LOL. On Fri, Feb 13, 2015 at 8:11 PM, Kurt Fankhauser <[ [email protected] ]( mailto:[email protected] )> wrote: Jeremy, I ended up having to default the units and then follow the quick start guide to the T. There must be some bugs to work out in the firmware cause when I ordered them the guy told me to follow the quick start to the T. Kurt Fankhauser Wavelinc Communications P.O. Box 126 Bucyrus, OH 44820 [ http://www.wavelinc.com ]( http://www.wavelinc.com/ ) tel. [ 419-562-6405 ]( tel:419-562-6405 ) fax. [ 419-617-0110 ]( tel:419-617-0110 ) On Fri, Feb 13, 2015 at 9:59 PM, Jeremy <[ [email protected] ]( mailto:[email protected] )> wrote: I also didn't follow the guide the first time. On subsequent attempts I did, but it seemed like something was wrong with them at that point. Anyway, it's nice to see someone having some success. The platform looks like it has a lot of potential. On Fri, Feb 13, 2015 at 7:50 PM, Kurt Fankhauser <[ [email protected] ]( mailto:[email protected] )> wrote: Jeremy, Yes I had issues but I didn't call support. It took me almost 2 hours to get the two radios to see each other but I finally got them too. I wasn't following the PTP quick start guide like I was told to. When I initially configured the radios I disabled the 2nd port (called WAN) in the manual. For some reason they would not link until I turned it back on. Even though I wasn't using the WAN port. Kurt Fankhauser Wavelinc Communications P.O. Box 126 Bucyrus, OH 44820 [ http://www.wavelinc.com ]( http://www.wavelinc.com/ ) tel. [ 419-562-6405 ]( tel:419-562-6405 ) fax. [ 419-617-0110 ]( tel:419-617-0110 ) On Fri, Feb 13, 2015 at 9:45 PM, Jeremy <[ [email protected] ]( mailto:[email protected] )> wrote: I had some issues with the configuration and couldn't ever get them to pass traffic. Did you run into any issues that required support? On Fri, Feb 13, 2015 at 7:38 PM, Rory Conaway <[ [email protected] ]( mailto:[email protected] )> wrote: I saw that too when I was reviewing the brochure this morning. I was just assuming they were considering this a long range product. Kurt, do you mind telling me what those radios cost? Rory From: Af [mailto:[ [email protected] ]( mailto:[email protected] )] On Behalf Of Kurt Fankhauser Sent: Friday, February 13, 2015 7:36 PM To: [ [email protected] ]( mailto:[email protected] ) Subject: [AFMUG] Trango Altum AC PTP test results Just got done testing a Trango Altum AC PTP link on the bench. Units are 25db integrated panels. Did a 40mhz channel test and 80mhz via UDP. I tried a TCP test between two RB2011's and best I seen was 175-180'ish and that was with both 40 and 80mhz channels. CPU seemed to be maxing out on the 2011's. Has UNI-1 bands and ISM bands. I was hoping it had the middle DFS bands but it doesn't :( Kurt Fankhauser Wavelinc Communications P.O. Box 126 Bucyrus, OH 44820 [ http://www.wavelinc.com ]( http://www.wavelinc.com/ ) tel. [ 419-562-6405 ]( tel:419-562-6405 ) fax. [ 419-617-0110 ]( tel:419-617-0110 )
