My fave is the "I pressed the reset several times an plugged in a blue
cable I found"
Router is placed into a loop because the blue cable is plugged into 2
separate ports.
Make me want to use an .50 cal eagle and blow a hole in it and state
that should do it :)
On 02/16/2015 03:42 PM, Josh Luthman wrote:
By witchcraft you mean possibly broken?
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Mon, Feb 16, 2015 at 4:39 PM, That One Guy
<[email protected] <mailto:[email protected]>> wrote:
Is there any good reason this customer router would be bridging
the internal device MACs? Theyre showing up on the bridging table
in the canopy radio, but as best I can tell theyre getting their
DHCP address from the router and not actually causing a problem.
Is this some sort of witchcraft on Belkins part?
--
All parts should go together without forcing. You must remember
that the parts you are reassembling were disassembled by you.
Therefore, if you can't get them together again, there must be a
reason. By all means, do not use a hammer. -- IBM maintenance
manual, 1925
