our tech was onsite, replaced a bad cable, this was a new router the customer had to replace ours. Ive seen dlinks lock in switch mode on boot, but it fully bridges, The Apple routers, if they detect a non routable IP on the WAN will switch to AP only mode, but this is in router mode, up and running without a problem. The MACs coming through are only wireless devices, he connected to the wireless to verify he had interwebs and he did, getting IP from the routers DHCP server, those device DHCP requests arent coming out, just very odd to see
On Mon, Feb 16, 2015 at 3:42 PM, Ty Featherling <[email protected]> wrote: > I've seen this with a handful of routers. Some weird bug I guess. The > customer doesn't complain of issues, I just see multiple MACs on their > radio's bridge table. Only the WAN MAC of the router pulls dhcp from us. > > -Ty > > On Mon, Feb 16, 2015 at 3:39 PM, That One Guy <[email protected]> > wrote: > >> Is there any good reason this customer router would be bridging the >> internal device MACs? Theyre showing up on the bridging table in the canopy >> radio, but as best I can tell theyre getting their DHCP address from the >> router and not actually causing a problem. Is this some sort of witchcraft >> on Belkins part? >> >> -- >> All parts should go together without forcing. You must remember that the >> parts you are reassembling were disassembled by you. Therefore, if you >> can't get them together again, there must be a reason. By all means, do not >> use a hammer. -- IBM maintenance manual, 1925 >> > > -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
