We found there is a mode you can set in those routers to AP mode which
makes it a switch for all interfaces.
Net gear will do this also.
On 02/16/2015 03:51 PM, That One Guy wrote:
our tech was onsite, replaced a bad cable, this was a new router the
customer had to replace ours. Ive seen dlinks lock in switch mode on
boot, but it fully bridges, The Apple routers, if they detect a non
routable IP on the WAN will switch to AP only mode, but this is in
router mode, up and running without a problem. The MACs coming through
are only wireless devices, he connected to the wireless to verify he
had interwebs and he did, getting IP from the routers DHCP server,
those device DHCP requests arent coming out, just very odd to see
On Mon, Feb 16, 2015 at 3:42 PM, Ty Featherling
<[email protected] <mailto:[email protected]>> wrote:
I've seen this with a handful of routers. Some weird bug I guess.
The customer doesn't complain of issues, I just see multiple MACs
on their radio's bridge table. Only the WAN MAC of the router
pulls dhcp from us.
-Ty
On Mon, Feb 16, 2015 at 3:39 PM, That One Guy
<[email protected] <mailto:[email protected]>> wrote:
Is there any good reason this customer router would be
bridging the internal device MACs? Theyre showing up on the
bridging table in the canopy radio, but as best I can tell
theyre getting their DHCP address from the router and not
actually causing a problem. Is this some sort of witchcraft on
Belkins part?
--
All parts should go together without forcing. You must
remember that the parts you are reassembling were disassembled
by you. Therefore, if you can't get them together again, there
must be a reason. By all means, do not use a hammer. -- IBM
maintenance manual, 1925
--
All parts should go together without forcing. You must remember that
the parts you are reassembling were disassembled by you. Therefore, if
you can't get them together again, there must be a reason. By all
means, do not use a hammer. -- IBM maintenance manual, 1925
