Local phone guy was using something like that for keeping most of the
twist in his twisted pairs.
bp
<part15sbs{at}gmail{dot}com>
On 2/19/2015 9:56 AM, Ken Hohhof wrote:
Sounds like they are referring to this:
http://www.alliedelec.com/3m-u1r/70112963/
*From:* Nate Burke <mailto:[email protected]>
*Sent:* Thursday, February 19, 2015 10:51 AM
*To:* [email protected] <mailto:[email protected]>
*Subject:* Re: [AFMUG] Cat5 Splicing
I wouldn't use the pictured one either, but supposedly there is a
product like this, but specific for Cat5/6 where the pair go into the
connector. It would replace doing a punchdown splice block or RJ45
coupler.
On 2/19/2015 10:50 AM, That One Guy wrote:
we have come across a few customer splices using the redcaps, if
theyre going to splice themselves, at least theyre using a quality
product to do it wrong
On Thu, Feb 19, 2015 at 10:44 AM, Josh Luthman
<[email protected] <mailto:[email protected]>> wrote:
There's a shielded one at Mouser. I would never use what's in
that picture for ethernet.
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
On Feb 19, 2015 11:42 AM, "Nate Burke" <[email protected]
<mailto:[email protected]>> wrote:
Do you have a partnumber/distributor?
On 2/19/2015 10:40 AM, SmarterBroadband wrote:
We use them. Gel filled so they are water resistant.
Adam
*From:*Af [mailto:[email protected]] *On Behalf Of *Nate
Burke
*Sent:* Thursday, February 19, 2015 8:38 AM
*To:* Animal Farm
*Subject:* [AFMUG] Cat5 Splicing
Out at AF I was talking to some who said that they were
using a Cat5 splice product. They described it as being
similar to a butt connector
Image result for cat5 splice keep twist
but was specifically made to accept the Cat5 twist, so that
the twist went all the way into the unit to splice with
another twist. I've been searching around, but haven't been
able to find them. I can see this being better than trying
to do an RJ45 coupler in some situations. Anybody use
something similar to this?
--
All parts should go together without forcing. You must remember that
the parts you are reassembling were disassembled by you. Therefore,
if you can't get them together again, there must be a reason. By all
means, do not use a hammer. -- IBM maintenance manual, 1925
