We have used those for a while. We also use DC4 in the coupler inside,
and then wrap the outside with silicon tape. They have lasted for years
without leaks/failures.
bp
<part15sbs{at}gmail{dot}com>
On 2/19/2015 8:53 AM, Josh Luthman wrote:
Manufacturer: Bulgin PX0777/UTPCurrent Rating: 1.5 AVoltage Rating: 30
VAC / 42 VDC
Mouser
http://www.mouser.com/Search/ProductDetail.aspx?qs=p08Uhw9w2FyOGS2yhLmq6g==
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Feb 19, 2015 11:51 AM, "Nate Burke" <n...@blastcomm.com
<mailto:n...@blastcomm.com>> wrote:
I wouldn't use the pictured one either, but supposedly there is a
product like this, but specific for Cat5/6 where the pair go into
the connector. It would replace doing a punchdown splice block or
RJ45 coupler.
On 2/19/2015 10:50 AM, That One Guy wrote:
we have come across a few customer splices using the redcaps, if
theyre going to splice themselves, at least theyre using a
quality product to do it wrong
On Thu, Feb 19, 2015 at 10:44 AM, Josh Luthman
<j...@imaginenetworksllc.com
<mailto:j...@imaginenetworksllc.com>> wrote:
There's a shielded one at Mouser. I would never use what's
in that picture for ethernet.
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
On Feb 19, 2015 11:42 AM, "Nate Burke" <n...@blastcomm.com
<mailto:n...@blastcomm.com>> wrote:
Do you have a partnumber/distributor?
On 2/19/2015 10:40 AM, SmarterBroadband wrote:
We use them. Gel filled so they are water resistant.
Adam
*From:*Af [mailto:af-boun...@afmug.com] *On Behalf Of
*Nate Burke
*Sent:* Thursday, February 19, 2015 8:38 AM
*To:* Animal Farm
*Subject:* [AFMUG] Cat5 Splicing
Out at AF I was talking to some who said that they were
using a Cat5 splice product. They described it as being
similar to a butt connector
Image result for cat5 splice keep twist
but was specifically made to accept the Cat5 twist, so
that the twist went all the way into the unit to splice
with another twist. I've been searching around, but
haven't been able to find them. I can see this being
better than trying to do an RJ45 coupler in some
situations. Anybody use something similar to this?
--
All parts should go together without forcing. You must remember
that the parts you are reassembling were disassembled by you.
Therefore, if you can't get them together again, there must be a
reason. By all means, do not use a hammer. -- IBM maintenance
manual, 1925