The tower was made by Arris I believe and it took special designed
mounts for the larger standoffs like this one.
I would think that a fabrication shop could make what you need if
given enough measurements at the height you need.
On 02/19/2015 12:24 PM, Ryan Mano wrote:
The pipe that you are using to hold the sectors how did you mount that
to the tower?
How you have your setup there is what am looking for
*From:*Af [mailto:[email protected]] *On Behalf Of *David
*Sent:* Thursday, February 19, 2015 11:25 AM
*To:* [email protected]
*Subject:* Re: [AFMUG] mount for tower
Here a couple pics.
On 02/19/2015 09:37 AM, Ken Hohhof wrote:
MTOW-P
http://www.wbmfg.com/products.cfm?PID=34
*From:*Vince West <mailto:[email protected]>
*Sent:*Thursday, February 19, 2015 9:22 AM
*To:*[email protected] <mailto:[email protected]>
*Subject:*Re: [AFMUG] mount for tower
I would use an M-TOW
<http://www.wbmfg.com/pdf.cfm/WBMfg-Tower%20Mount.pdf?pid=27> or
M-TOW-10
<http://www.wbmfg.com/pdf.cfm/WBMfg-Tower%20Mount.pdf?pid=27> (not
sure what the spacing is on the bracket for the Cyclone AP). I use
a lot of the M-TOW-10 just because I like having the extra space
on the mount.
Vince West
Tower Hand
Technical Support
Shelby Broadband
148 Citizens Blvd
Simpsonville, KY 40067
Phone: 1-888-364-4232
On Thu, Feb 19, 2015 at 9:07 AM, Ryan Mano
<[email protected] <mailto:[email protected]>>
wrote:
I need to mount an omni cyclone on the side of the dmx
tower…what tower mount should I get from wb manufacturing?
thanks
