The PTP mode has been there. It allows to turn about the power to 30dbm in 5.8. I had a radio running at 30dbm and it would crap out within 12 hours - ethernet port would quit working. I dropped it to 28dbm and it works fine YMMV. The new PTP master/slave mode was supposed to cut latency - from what I saw it only cut it by about 5ms and the performance cut was dramatic. John Woodfield, President Delmarva WiFi Inc. 410-870-WiFi
-----Original Message----- From: "George Skorup (Cyber Broadcasting)" <[email protected]> Sent: Tuesday, March 10, 2015 2:57am To: [email protected] Subject: Re: [AFMUG] ePMP Release 2.4 is Now Available If that's the case, then that's not cool. I see there's two PTP modes though. One is ePTP Master and Slave. The other is just PTP. Look like the PTP mode requires fixed distance settings at both ends? And ePTP mode does auto-ranging like Canopy BHM/BHSs perhaps? When are we going to get 2.5ms framing to sync with Canopy? I see we can now turn on the aux port PoE output and it'll power another ePMP or Canopy SM. PTP from a customer's barn to their house got easier. But that additional 20ms of latency is not so good, so hopefully PTP mode for a 1000' link works. On 3/9/2015 8:36 PM, John Woodfield wrote: This new mode of operation increases retransmits and cuts throughput in half in environments with any noise from what I've seen so far. John Woodfield, President Delmarva WiFi Inc. 410-870-WiFi -----Original Message----- From: "Mike Hammett" [ <[email protected]> ]( mailto:[email protected] ) Sent: Monday, March 9, 2015 3:38pm To: [ [email protected] ]( mailto:[email protected] ) Subject: Re: [AFMUG] ePMP Release 2.4 is Now Available ePMP Release 2.4 includes new enhancements to eFortify™ and eCommand™. Check out the details at [ http://bit.ly/1BYo2ja ]( http://bit.ly/1BYo2ja ) Ray Join the Conversation [ Cambium Networks Community Forum ]( http://community.cambiumnetworks.com/ )
