I do not have any cable loss set... On Thu, Apr 23, 2015 at 7:21 PM, Jeremy <[email protected]> wrote:
> I have the db of the antennas entered and it was set to 54 db but it auto > sets the gain based on antenna size. Everything is set correctly, unless > there is some 'trick' to it. I was under the impression that these things > set their own gain based on antenna size and EIRP. The EIRP shows (limited) > > On Thu, Apr 23, 2015 at 7:15 PM, Josh Luthman <[email protected] > > wrote: > >> Do you have the gain set right? >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> On Apr 23, 2015 9:01 PM, "Jeremy" <[email protected]> wrote: >> >>> 14db off can't be right at -57. Lights are inconsequential for me. >>> Anyway, UBNT support has contacted me about possibilities for improving the >>> link. We're looking at it now (not that it needs much improvement). How >>> is that for customer support? They reached out to me. >>> >>> On Thu, Apr 23, 2015 at 6:57 PM, Josh Luthman < >>> [email protected]> wrote: >>> >>>> Lights are right on for me. Blinking red would be 14db off I think. >>>> Blinking blue is 1 off. >>>> >>>> Josh Luthman >>>> Office: 937-552-2340 >>>> Direct: 937-552-2343 >>>> 1100 Wayne St >>>> Suite 1337 >>>> Troy, OH 45373 >>>> On Apr 23, 2015 8:49 PM, "Jeremy" <[email protected]> wrote: >>>> >>>>> There have been murmurs of multipoint being a possibility, nothing yet. >>>>> >>>>> On Thu, Apr 23, 2015 at 6:07 PM, Jon Langeler < >>>>> [email protected]> wrote: >>>>> >>>>>> Is multipoint in the future? white space? >>>>>> >>>>>> Sent from my iPhone >>>>>> >>>>>> On Apr 23, 2015, at 6:53 PM, Ben Moore <[email protected]> wrote: >>>>>> >>>>>> Thanks for the great feedback! >>>>>> >>>>>> More units will be arriving next week. >>>>>> >>>>>> Regards, >>>>>> Ben >>>>>> >>>>>> On Thu, Apr 23, 2015 at 4:52 PM, Jeremy <[email protected]> >>>>>> wrote: >>>>>> >>>>>>> These things are amazing! I just finished converting to dual slant. >>>>>>> 34dbi dish on one side, 30dbi dish on the other, 7.75 miles, RX -57 >>>>>>> (all >>>>>>> chains), 40Mhz channel width, modulation hovering between QAM16 and >>>>>>> QAM64. >>>>>>> Seeing 260-275Mbps down by 60Mbps up on a 75% duty cycle. >>>>>>> >>>>>>> The lights don't seem to work right as far as alignment goes. I >>>>>>> spent forever fine tuning through the gui and the lights are still >>>>>>> blinking >>>>>>> red, one signal level. I wouldn't align with lights anyway. I am >>>>>>> extremely impressed with these. Now if only anywhere still had them in >>>>>>> stock.... >>>>>>> >>>>>>> On Sun, Apr 19, 2015 at 1:00 PM, Josh Luthman < >>>>>>> [email protected]> wrote: >>>>>>> >>>>>>>> I'd suggest you try the upgrade. I haven't had any DFS problems >>>>>>>> outside. >>>>>>>> >>>>>>>> >>>>>>>> Josh Luthman >>>>>>>> Office: 937-552-2340 >>>>>>>> Direct: 937-552-2343 >>>>>>>> 1100 Wayne St >>>>>>>> Suite 1337 >>>>>>>> Troy, OH 45373 >>>>>>>> >>>>>>>> On Sun, Apr 19, 2015 at 2:56 PM, Kurt Fankhauser < >>>>>>>> [email protected]> wrote: >>>>>>>> >>>>>>>>> shipped release >>>>>>>>> >>>>>>>>> Sent from my iPhone >>>>>>>>> >>>>>>>>> Kurt Fankhauser >>>>>>>>> Wavelinc Communications >>>>>>>>> P.O. Box 126 >>>>>>>>> Bucyrus, OH 44820 >>>>>>>>> http://www.wavelinc.com >>>>>>>>> tel. 419-562-6405 >>>>>>>>> fax. 419-617-0110 >>>>>>>>> >>>>>>>>> On Apr 19, 2015, at 12:48 PM, Josh Luthman < >>>>>>>>> [email protected]> wrote: >>>>>>>>> >>>>>>>>> Are you on 3.0 or the shipped release? >>>>>>>>> >>>>>>>>> >>>>>>>>> Josh Luthman >>>>>>>>> Office: 937-552-2340 >>>>>>>>> Direct: 937-552-2343 >>>>>>>>> 1100 Wayne St >>>>>>>>> Suite 1337 >>>>>>>>> Troy, OH 45373 >>>>>>>>> >>>>>>>>> On Sun, Apr 19, 2015 at 12:31 PM, Kurt Fankhauser < >>>>>>>>> [email protected]> wrote: >>>>>>>>> >>>>>>>>>> Josh, >>>>>>>>>> >>>>>>>>>> I did set it while in the DFS bands and still didn't make any >>>>>>>>>> difference. >>>>>>>>>> >>>>>>>>>> >>>>>>>>>> Kurt Fankhauser >>>>>>>>>> >>>>>>>>>> Wavelinc Communications >>>>>>>>>> >>>>>>>>>> P.O. Box 126 >>>>>>>>>> >>>>>>>>>> Bucyrus, OH 44820 >>>>>>>>>> >>>>>>>>>> http://www.wavelinc.com >>>>>>>>>> >>>>>>>>>> tel. 419-562-6405 >>>>>>>>>> >>>>>>>>>> fax. 419-617-0110 >>>>>>>>>> >>>>>>>>>> On Sat, Apr 18, 2015 at 10:59 PM, Josh Luthman < >>>>>>>>>> [email protected]> wrote: >>>>>>>>>> >>>>>>>>>>> Definitely set it in the DFS band! >>>>>>>>>>> >>>>>>>>>>> Josh Luthman >>>>>>>>>>> Office: 937-552-2340 >>>>>>>>>>> Direct: 937-552-2343 >>>>>>>>>>> 1100 Wayne St >>>>>>>>>>> Suite 1337 >>>>>>>>>>> Troy, OH 45373 >>>>>>>>>>> On Apr 18, 2015 10:06 PM, "Kurt Fankhauser" <[email protected]> >>>>>>>>>>> wrote: >>>>>>>>>>> >>>>>>>>>>>> Ken, >>>>>>>>>>>> This is V/H polarity. Don't really see any need for slant on >>>>>>>>>>>> this link. I'm limited for antenna options right now anyway. But >>>>>>>>>>>> these are >>>>>>>>>>>> working great so I don't think I'm going to mess with them. >>>>>>>>>>>> >>>>>>>>>>>> Josh, >>>>>>>>>>>> No I did not set antenna gain. >>>>>>>>>>>> >>>>>>>>>>>> >>>>>>>>>>>> Kurt Fankhauser >>>>>>>>>>>> >>>>>>>>>>>> Wavelinc Communications >>>>>>>>>>>> >>>>>>>>>>>> P.O. Box 126 >>>>>>>>>>>> >>>>>>>>>>>> Bucyrus, OH 44820 >>>>>>>>>>>> >>>>>>>>>>>> http://www.wavelinc.com >>>>>>>>>>>> >>>>>>>>>>>> tel. 419-562-6405 >>>>>>>>>>>> >>>>>>>>>>>> fax. 419-617-0110 >>>>>>>>>>>> >>>>>>>>>>>> On Sat, Apr 18, 2015 at 9:52 PM, Josh Reynolds < >>>>>>>>>>>> [email protected]> wrote: >>>>>>>>>>>> >>>>>>>>>>>>> There isn't really ATPC per say. There are some.. Similar >>>>>>>>>>>>> options in 3.x firmware. Have you read Chuck's post on how the AF >>>>>>>>>>>>> won't >>>>>>>>>>>>> really let you "cheat" on EIRP? Has to do with distance >>>>>>>>>>>>> calculations, tx >>>>>>>>>>>>> power, etc. >>>>>>>>>>>>> >>>>>>>>>>>>> >>>>>>>>>>>>> On April 18, 2015 5:05:43 PM AKDT, Josh Luthman < >>>>>>>>>>>>> [email protected]> wrote: >>>>>>>>>>>>>> >>>>>>>>>>>>>> The EIRP is messed up unless the ATPC brought mine down to to >>>>>>>>>>>>>> -60. I've got it at 25eirp with 19dbi antenna. >>>>>>>>>>>>>> >>>>>>>>>>>>>> Josh Luthman >>>>>>>>>>>>>> Office: 937-552-2340 >>>>>>>>>>>>>> Direct: 937-552-2343 >>>>>>>>>>>>>> 1100 Wayne St >>>>>>>>>>>>>> Suite 1337 >>>>>>>>>>>>>> Troy, OH 45373 >>>>>>>>>>>>>> On Apr 18, 2015 8:58 PM, "Mathew Howard" < >>>>>>>>>>>>>> [email protected]> wrote: >>>>>>>>>>>>>> >>>>>>>>>>>>>>> looks to me like the antenna gain is at 0db, since it's >>>>>>>>>>>>>>> saying it's limiting it to 15dbm EIRP... not that it actually >>>>>>>>>>>>>>> makes any >>>>>>>>>>>>>>> difference, since the TX power is going to be at 15dbm either >>>>>>>>>>>>>>> way... it'll >>>>>>>>>>>>>>> just be showing 38 on the interface. >>>>>>>>>>>>>>> >>>>>>>>>>>>>>> On Sat, Apr 18, 2015 at 7:54 PM, Josh Luthman < >>>>>>>>>>>>>>> [email protected]> wrote: >>>>>>>>>>>>>>> >>>>>>>>>>>>>>>> Did you set 23dbi gain? >>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>> Josh Luthman >>>>>>>>>>>>>>>> Office: 937-552-2340 >>>>>>>>>>>>>>>> Direct: 937-552-2343 >>>>>>>>>>>>>>>> 1100 Wayne St >>>>>>>>>>>>>>>> Suite 1337 >>>>>>>>>>>>>>>> Troy, OH 45373 >>>>>>>>>>>>>>>> On Apr 18, 2015 8:40 PM, "Kurt Fankhauser" < >>>>>>>>>>>>>>>> [email protected]> wrote: >>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> First link up. Havn't even fine tuned anything yet. ARC >>>>>>>>>>>>>>>>> panels on both ends. >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> Initially tried to use DFS freqs and kept getting radar >>>>>>>>>>>>>>>>> detect. Even though I was 50mhz away from anything else 5ghz >>>>>>>>>>>>>>>>> on the same >>>>>>>>>>>>>>>>> tower. Pretty sure the radar detection was coming from itself >>>>>>>>>>>>>>>>> because it >>>>>>>>>>>>>>>>> would pass the initial bootup listen period and once it >>>>>>>>>>>>>>>>> started >>>>>>>>>>>>>>>>> transmitting would then get the detections. So don't know >>>>>>>>>>>>>>>>> what that was >>>>>>>>>>>>>>>>> about. >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> Kurt Fankhauser >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> Wavelinc Communications >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> P.O. Box 126 >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> Bucyrus, OH 44820 >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> http://www.wavelinc.com >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> tel. 419-562-6405 >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>>> fax. 419-617-0110 >>>>>>>>>>>>>>>>> >>>>>>>>>>>>>>>> >>>>>>>>>>>>>>> >>>>>>>>>>>>> -- >>>>>>>>>>>>> Sent from my Android device with K-9 Mail. Please excuse my >>>>>>>>>>>>> brevity. >>>>>>>>>>>>> >>>>>>>>>>>> >>>>>>>>>>>> >>>>>>>>>> >>>>>>>>> >>>>>>>> >>>>>>> >>>>>> >>>>> >>> >
