You hit the squirrels? From: Mike Hammett Sent: Sunday, May 10, 2015 1:57 PM To: [email protected] Subject: Re: [AFMUG] APC-DIN Mount
I never had it shoot, only slowly seep. After inspection of the tower, I am blaming squirrels for damaging most of the lines going up. Some have been hit a little harder than others. ----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com Midwest Internet Exchange http://www.midwest-ix.com -------------------------------------------------------------------------------- From: "Lewis Bergman" <[email protected]> To: [email protected] Sent: Sunday, May 10, 2015 1:32:00 PM Subject: Re: [AFMUG] APC-DIN Mount >From my experience, which may differ from yours, water always seemed to enter >the cable a good ways up the tower giving it some decent pressure allowing it >to shoot in any direction it was pointed. On May 10, 2015 3:46 AM, "Mike Hammett" <[email protected]> wrote: It's hard to tell from the picture. Must the chassis be mounted to the DIN rail via the back of the chassis or can the mount be relocated to the top\bottom? I assume it can't be moved, but I'd like to mount it so that the ports of the surge suppressors are pointing down. Should any water enter the cable, gravity would take it back out of the connector, down the side of the cable instead out the back of the connector, down onto the next surge suppressor below it. I could just put a DIN rail at the top of the box, but just wondering if I could just use the same rail I'm using for everything else. No, it's not green cable and there shouldn't be any wear points, so I'm not really sure how it's getting in. ----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com Midwest Internet Exchange http://www.midwest-ix.com
