With mine it was, yes.
 
 
 
John Woodfield, President
Delmarva WiFi Inc.
410-870-WiFi


-----Original Message-----
From: "Josh Reynolds" <[email protected]>
Sent: Saturday, May 16, 2015 3:49pm
To: [email protected]
Subject: Re: [AFMUG] epmp lockups



Quick question...

Is the wireless interface itself still up and broadcasting during this 
time?

On 2015-05-16 12:48 pm, George Skorup (Cyber Broadcasting) wrote:
> I've had a couple regular connectorized radios in AP mode appear to
> crash. Logged into the MikroTiks they're attached to, interface shows
> up at 100FDX, no traffic, can't ping it. Bouncing the MT interface
> brought them back, no reboot required. No other radios at the sites
> had any issues. Hasn't happened again in months, so I don't know what
> the problem may have been at the time. And I haven't messed with
> firmware on those either.
> 
> On 5/16/2015 10:27 AM, CBB - Jay Fuller wrote:
> 
>> on three different radios on two towers? :)
>> 
>> ----- Original Message -----
>> FROM: Josh Luthman
>> TO: [email protected]
>> SENT: Saturday, May 16, 2015 9:34 AM
>> SUBJECT: Re: [AFMUG] epmp lockups
>> 
>> Bad Ethernet port? Replace it.
>> 
>> Josh Luthman
>> Office: 937-552-2340
>> Direct: 937-552-2343
>> 1100 Wayne St
>> Suite 1337
>> Troy, OH 45373
>> On May 16, 2015 10:08 AM, "CBB - Jay Fuller"
>> <[email protected]> wrote:
>> 
>> We're running some EPMP 2.4 - recently, we've seen a higher number
>> of lockups than normal. I would say in the 6 months or so we've
>> been running it, i've certainly seen at least one lockup with each
>> access point.
>> 
>> A few questions -
>> 
>> Is anyone else seeing this, or are we just lucky?
>> 
>> If so, is there a firmware version you see this less?
>> 
>> We have rebooters at most of the sites it's occurring but at least
>> one site I know doesn't have one.
>> (i know cause i had someone out there at 1:30 this morning and now
>> i'm about to go out there!)
>> 
>> Thanks!
>> -jf

-- 
josh reynolds :: chief information officer
spitwspots :: www.spitwspots.com

Reply via email to