In the first case the wireless interface went down as well. I was pulling up the radio to check on the status of a technician that was installing a customer on the unit and it crashed before it pulled completely up. The tech called me a minute later to see why the AP had disappeared. Not sure if that was the case in subsequent lockups. Incidentally, I accidentally typed the address of the unit last night but the page didn't load and didn't think anything about it and then looked at alerts and the unit was reported as down a few minutes later.

Josh Reynolds wrote:
Quick question...

Is the wireless interface itself still up and broadcasting during this time?

On 2015-05-16 12:48 pm, George Skorup (Cyber Broadcasting) wrote:
I've had a couple regular connectorized radios in AP mode appear to
crash. Logged into the MikroTiks they're attached to, interface shows
up at 100FDX, no traffic, can't ping it. Bouncing the MT interface
brought them back, no reboot required. No other radios at the sites
had any issues. Hasn't happened again in months, so I don't know what
the problem may have been at the time. And I haven't messed with
firmware on those either.

On 5/16/2015 10:27 AM, CBB - Jay Fuller wrote:

on three different radios on two towers? :)

----- Original Message -----
FROM: Josh Luthman
TO: [email protected]
SENT: Saturday, May 16, 2015 9:34 AM
SUBJECT: Re: [AFMUG] epmp lockups

Bad Ethernet port? Replace it.

Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On May 16, 2015 10:08 AM, "CBB - Jay Fuller"
<[email protected]> wrote:

We're running some EPMP 2.4 - recently, we've seen a higher number
of lockups than normal. I would say in the 6 months or so we've
been running it, i've certainly seen at least one lockup with each
access point.

A few questions -

Is anyone else seeing this, or are we just lucky?

If so, is there a firmware version you see this less?

We have rebooters at most of the sites it's occurring but at least
one site I know doesn't have one.
(i know cause i had someone out there at 1:30 this morning and now
i'm about to go out there!)

Thanks!
-jf


Reply via email to