stop pulling the page up mr weekley!!! lol i think i'll load that release candidate soon. (late tonight maybe) ----- Original Message ----- From: George Skorup (Cyber Broadcasting) To: [email protected] Sent: Saturday, May 16, 2015 4:05 PM Subject: Re: [AFMUG] epmp lockups
I'll admit we don't have a lot of ePMP up, but I haven't had many issues with it. Besides the screwy data display issues like the bridge tables which now appears to be mostly fixed with R2.4.2. The two radios with what appeared to be locked up ethernet interfaces could've just been flukes. Who knows. And they haven't done it since then. On 5/16/2015 3:36 PM, Jay Weekley wrote: > In the first case the wireless interface went down as well. I was > pulling up the radio to check on the status of a technician that was > installing a customer on the unit and it crashed before it pulled > completely up. The tech called me a minute later to see why the AP > had disappeared. Not sure if that was the case in subsequent lockups. > Incidentally, I accidentally typed the address of the unit last night > but the page didn't load and didn't think anything about it and then > looked at alerts and the unit was reported as down a few minutes later. > > Josh Reynolds wrote: >> Quick question... >> >> Is the wireless interface itself still up and broadcasting during >> this time? >> >> On 2015-05-16 12:48 pm, George Skorup (Cyber Broadcasting) wrote: >>> I've had a couple regular connectorized radios in AP mode appear to >>> crash. Logged into the MikroTiks they're attached to, interface shows >>> up at 100FDX, no traffic, can't ping it. Bouncing the MT interface >>> brought them back, no reboot required. No other radios at the sites >>> had any issues. Hasn't happened again in months, so I don't know what >>> the problem may have been at the time. And I haven't messed with >>> firmware on those either. >>> >>> On 5/16/2015 10:27 AM, CBB - Jay Fuller wrote: >>> >>>> on three different radios on two towers? :) >>>> >>>> ----- Original Message ----- >>>> FROM: Josh Luthman >>>> TO: [email protected] >>>> SENT: Saturday, May 16, 2015 9:34 AM >>>> SUBJECT: Re: [AFMUG] epmp lockups >>>> >>>> Bad Ethernet port? Replace it. >>>> >>>> Josh Luthman >>>> Office: 937-552-2340 >>>> Direct: 937-552-2343 >>>> 1100 Wayne St >>>> Suite 1337 >>>> Troy, OH 45373 >>>> On May 16, 2015 10:08 AM, "CBB - Jay Fuller" >>>> <[email protected]> wrote: >>>> >>>> We're running some EPMP 2.4 - recently, we've seen a higher number >>>> of lockups than normal. I would say in the 6 months or so we've >>>> been running it, i've certainly seen at least one lockup with each >>>> access point. >>>> >>>> A few questions - >>>> >>>> Is anyone else seeing this, or are we just lucky? >>>> >>>> If so, is there a firmware version you see this less? >>>> >>>> We have rebooters at most of the sites it's occurring but at least >>>> one site I know doesn't have one. >>>> (i know cause i had someone out there at 1:30 this morning and now >>>> i'm about to go out there!) >>>> >>>> Thanks! >>>> -jf >> >
