I you want exact replacement, I have ordered from McMaster-Carr:
18-8 Stainless Steel Hex Head Cap Screw, M8x1.25 thread, 140mm long, fully
threaded, $2.70 ea
18-8 Stainless Steel Serrated-Flange Locknut, M8x1.25 thread, $6.24 per pack
of 25
8 mm is very close to 5/16, so you could probably substitute 5/16-18 x 5 or
6 inches long to get more options.
-----Original Message-----
From: Matt
Sent: Friday, September 11, 2015 7:22 PM
To: [email protected]
Subject: Re: [AFMUG] Stainless Bolts
This a 450 sector. Where can I get replacement nuts and bolts?
On Fri, Sep 11, 2015 at 7:01 PM, TJ Trout <[email protected]> wrote:
I think a good soak of penetrating oil (wd40, etc) should allow them to be
removed, get some silicone bronze nuts and get the problem over for good
On Fri, Sep 11, 2015 at 4:39 PM, Matt <[email protected]> wrote:
Is there a spray that can be used to loosen stainless bolts that are
just starting to seize? They still turn a bit but I dared not try any
farther. Pre sprayed them with CRC silicone spray but they still
seized. Was wandering if there was something better then the silicone
spray I could use?
