------------------------- ...................The radio supports an input voltage range of 23 – 56 V and the PoE interface is 802.3af compliant.
...................Alternatively, the radio can be powered by 802.3af PoE compliant switches. --------------------------------------------- Faisal Imtiaz Snappy Internet & Telecom 7266 SW 48 Street Miami, FL 33155 Tel: 305 663 5518 x 232 Help-desk: (305)663-5518 Option 2 or Email: [email protected] > From: "Josh Luthman" <[email protected]> > To: [email protected] > Cc: "Principal WISPA Member List" <[email protected]>, "[email protected]" > <[email protected]> > Sent: Wednesday, October 7, 2015 2:13:05 PM > Subject: Re: [WISPA Members] [AFMUG] ePMP Poe pinout for Netonix Switch > It doesn't say that under 2.3 under powering - where do you see it?? > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > On Wed, Oct 7, 2015 at 2:11 PM, Faisal Imtiaz < [email protected] > > wrote: >> It is always the best to check the exact specs on the radio spec sheet... >> See enclosed.... According to it, ONLY the Connectorized w/SYNC (AP) Radios >> appear to be 'dual polarized' on the poe side. >> You can power them with the standard 802.3af poe switch...(24v or 48v) >> So, you should be able to use the straight cable into the Netonix for these. >> (The spec sheet also implies that the integrated radios or the ones without >> SYNC >> are not dual polarized on the poe...) >> Regards. >> Faisal Imtiaz >> Snappy Internet & Telecom >> 7266 SW 48 Street >> Miami, FL 33155 >> Tel: 305 663 5518 x 232 >> Help-desk: (305)663-5518 Option 2 or Email: [email protected] >>> From: "Darin Steffl" < [email protected] > >>> To: [email protected] , " [email protected] " < [email protected] >, "Principal >>> WISPA >>> Member List" < [email protected] > >>> Sent: Wednesday, October 7, 2015 1:47:10 PM >>> Subject: [AFMUG] ePMP Poe pinout for Netonix Switch >>> Hello all, >>> We're going to power some ePMP GPS AP's with a Netonix switch. I understand >>> I >>> can power them with either 24V or 48V but the pinout is different than >>> standard >>> Ubiquiti passive POE that we're used to. >>> Which color wires do we swap on one side of the cable termination to >>> properly >>> power the ePMP GPS AP's? I found online possibly we swap the blue and brown >>> pairs but just want to double check here. >>> Thanks >>> -- >>> Darin Steffl >>> Minnesota WiFi >>> www.mnwifi.com >>> 507-634-WiFi >>> Like us on Facebook > _______________________________________________ > Members mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/members
