It doesn’t seem like you could buy the materials to make such a cable for $4, 
then there’s the labor.  How do they do it?

From: Mathew Howard 
Sent: Thursday, January 14, 2016 9:17 PM
To: af 
Subject: Re: [AFMUG] 900mhz PMP450i with dual polarity panel

I found some N male to rpsma at Streakwave for $4.

On Jan 14, 2016 9:05 PM, "Ken Hohhof" <[email protected]> wrote:

  The blue Mikrotik ones are ~ $8, but those are SMA to SMA.  And without the 
spark plug boots.

  From: Mathew Howard 
  Sent: Thursday, January 14, 2016 8:20 PM
  To: af 
  Subject: Re: [AFMUG] 900mhz PMP450i with dual polarity panel

  I don't know off hand what the cables cost, those were some I already had. I 
think I've gotten them for $3-5 each in the past. 

  On Jan 14, 2016 8:10 PM, "Chuck McCown" <[email protected]> wrote:

    If  it is SMA on the radio, I could  have flying leads coming out of the 
back of the antenna thereby dispensing with a couple of connectors.  

    How much did the cables cost  you?

    From: Mathew Howard 
    Sent: Thursday, January 14, 2016 6:56 PM
    To: af 
    Subject: Re: [AFMUG] 900mhz PMP450i with dual polarity panel

    Yeah, SMA on the radio. 
    No, those antennas didn't come with cables, I'm guessing they can supply 
cables, but I didn't think to ask... the antennas appear to be intended to use 
with ubnt Rockets (they have a holder for one built on), which would use the 
same connectors. 

    On Jan 14, 2016 7:50 PM, "Chuck McCown" <[email protected]> wrote:

      Cables and connectors are not cheap when manufacturing.  PITA.  Hmmm.
      SMA on the radio?

      Did the chinese antenna come with cables?

      From: Mathew Howard 
      Sent: Thursday, January 14, 2016 6:44 PM
      To: af 
      Subject: Re: [AFMUG] 900mhz PMP450i with dual polarity panel

      No, they don't come with cables - those are permanently attached to the 
Cambium yagis.

      On Jan 14, 2016 7:40 PM, "Chuck McCown" <[email protected]> wrote:

        Possibly.  I have the mold for the cover.  Back would be aluminum.  
Just need a nice pocket that slips over and interfaces with the radio.   Does 
the radio come with cables?

        From: Josh Luthman 
        Sent: Thursday, January 14, 2016 6:33 PM
        To: [email protected] 
        Subject: Re: [AFMUG] 900mhz PMP450i with dual polarity panel

        Slip on stinger would be way faster.  Could you match the price?

        Josh Luthman
        Office: 937-552-2340
        Direct: 937-552-2343
        1100 Wayne St
        Suite 1337
        Troy, OH 45373

        On Jan 14, 2016 8:31 PM, "Chuck McCown" <[email protected]> wrote:

          I would have to have a large commitment to meet that price for a slip 
on stinger version.  

          From: Mathew Howard 
          Sent: Thursday, January 14, 2016 5:58 PM
          To: af 
          Subject: Re: [AFMUG] 900mhz PMP450i with dual polarity panel

          This is the antenna: http://www.lanbowan.com/ANT915D12C-DP.htm 

          The antennas themselves are pretty cheap - they charged me 
$41.61/each, but shipping was quite expensive (they sent them DHL - there are 
obviously cheaper ways). I suspect that if you ordered a large enough quantity 
to get a decent shipping rate, even after adding jumper cables, it would still 
be a bit cheaper than the Cambium yagis.

          I did do a little testing with V/H... but it was kind of 
inconclusive, the signal level was only slightly weaker, but when I ran a link 
test, it was much worse - about 45m down vs 90m, I tried holding the Cambium 
yagi at a 45 degree angle and it was pretty similar results - 70m vs 90m and 
slightly weaker signal. I'm not sure if that was anything to do with the 
polarity being mismatched, or if it was just that H/V doesn't work as well as 
slant at that particular location... also, I was just holding thing antennas 
for the H/V tests and they were mounted at +/-45, so that could account for 
some of it too.

          On Thu, Jan 14, 2016 at 4:50 PM, Chuck McCown <[email protected]> wrote:

            What’s it cost?

            From: Mathew Howard 
            Sent: Thursday, January 14, 2016 3:36 PM
            To: af 
            Subject: [AFMUG] 900mhz PMP450i with dual polarity panel

            Fresh from China :)


            I tested it at two different customer's houses, and signal levels 
were consistently within 1db of the Cambium yagis. Not quite as clean of a 
package as the Cambium antennas, but it works and it's not a yagi... I did have 
to replace the bracket to make it dual slant though.

Reply via email to