We've been looking for an offset to take the din back far enough for the
packetflux stuff to be flush with the face of the rack, it's down to just
making some sheet metal and break
On Feb 27, 2016 1:48 PM, "Adam Moffett" <[email protected]> wrote:
> Come to think of it....I seem to think the DIN clip on the Site Monitors
> has two holes on it where you could screw it to a wall, or a panel, or
> whatever. DIN rail is so cheap that I would just keep using it though.
>
>
> On 2/27/2016 2:44 PM, Adam Moffett wrote:
>
>> I've been screwing the DIN to a 2U blank cover and mounting it on the
>> rear side of the rack, but still facing forwards.
>>
>> Like with the Meanwell PSU's in attached picture.
>>
>> On 2/27/2016 2:35 PM, Bill Prince wrote:
>>
>>> You can easily mount DIN rail on a couple of brackets and mount it in a
>>> regular 19" rack.
>>>
>>> bp
>>> <part15sbs{at}gmail{dot}com>
>>>
>>> On 2/27/2016 11:33 AM, Kurt Fankhauser wrote:
>>>
>>>> Is there any rackmount kits out there for the packet flux sync
>>>> injectors? Just looked over their website and only seen a DIN rail option?
>>>> Is anyone making something possibly 3rd party for this?
>>>>
>>>
>>>
>>
>
