That is what I was doing. No IP talking going on. Almost as if the laptop is not running the subnet mask.
From: CBB - Jay Fuller Sent: Saturday, November 5, 2016 1:04 PM To: [email protected] Subject: Re: [AFMUG] Have lost my marbles i think i would try to isolate one piece of equipment at a time can you talk to the netonix and nothing else? (connected directly) can you talk to the epmp and nothing else? (connected directly) check the netonix to make sure in system settings it does not restrict access coming from only one subnet. in fact, i think we had that problem as well and that was what i had to uncheck to be able to access it. good luck! lunchtime! war eagle! ----- Original Message ----- From: Chuck McCown To: [email protected] Sent: Saturday, November 05, 2016 1:47 PM Subject: Re: [AFMUG] Have lost my marbles Hooked up to lan, reconfigured IP settings, can talk to the world. This email is from the laptop. So, it has to be something dumb in the IP settings... I note netonix says to https and cambium is http. But more basic than that, I cannot ping 192.168.x.x Arrgh.. From: [email protected] Sent: Saturday, November 05, 2016 12:31 PM To: [email protected] Subject: [AFMUG] Have lost my marbles Trying to configure a Netonix switch and an epmp 2000. Dell Laptop. W10 getmac shows that the radio is present, so I presume that means my interface on the computer is functional. eth lights on the radio and switch both light. 192.168.0.100 - 255.255.255.0 is the laptop (took out everything else). Tried 255.255.0.0 mask Tried 192.168.1.10 address to talk to netonix at 192.168.1.20 No pings, no arp, no browsing etc. Tried different cables, power supplies etc. Gotta be something really silly. Or I have blown up my ethernet interface. I have to believe it is a user error... Something really basic. At some point I am going to have to connect that laptop to the lan to verify it can still talk to the world. But I am sure I must be misconfiguring something. I am sure nobody messed with the IPs of the radio and switch.
