I have four 5GHz 450i's running on our office tower fed from a GigE
PowerInjector+Sync. They're running 14.1.2. They received sync shortly
after boot, DFS, etc. BTW, no GigE-APC's in line on these yet. I'm like
two short at the moment. But we know that 1000Base-T and sync over power
+ the older APC's don't play nice anyway.
On 11/21/2016 1:23 PM, Mathew Howard wrote:
I've had a couple of them where I wasn't getting sync and couldn't
figure out why... in one case (maybe both... I don't remember off
hand), I was getting sync to an ePMP, but not to a PMP450i 900mhz AP
that were both plugged into the same sync injector... I didn't really
need sync on the 900mhz at the time, so I just switched it to generate
it's own timing, and I haven't gotten around to trying to figure it
out yet, but now I'm wondering if it would eventually come up if I
left it alone.
On Mon, Nov 21, 2016 at 12:45 PM, Seth Mattinen <[email protected]
<mailto:[email protected]>> wrote:
On 11/21/16 10:39, [email protected] <mailto:[email protected]> wrote:
I had all the packet flux gear running for days, plugged in
the 450i and
started trying to figure out why it was not receiving sync.
Half hour
or more later it said it was OK, so the delay had to be
Cambium, not
Packetflux.
Check if the packetflux says it has fix and 1PPS is active on the
binary tab and that the used pulse count is increasing on the
analog tab.
~Seth
