You should really use SiteMonitors if you use SyncInjectors. It allows you to manage and monitor the SyncInjector.
On Tue, Nov 22, 2016 at 10:37 AM, Kurt Fankhauser <[email protected]> wrote: > I just received my first powerinjector + sync today. If I want to power > some Airfibers with these do I need to turn the sync off for those ports? I > don't see a jumper to turn off sync, is it ok to provider sync on a port > with an Airfiber? Does it hurt anything? It looks to me like the only way > to turn off sync is buy the additional site monitor base thing to hookup to > it and turn it off through the web interface? > > On Mon, Nov 21, 2016 at 2:39 PM, George Skorup <[email protected]> wrote: > >> I have four 5GHz 450i's running on our office tower fed from a GigE >> PowerInjector+Sync. They're running 14.1.2. They received sync shortly >> after boot, DFS, etc. BTW, no GigE-APC's in line on these yet. I'm like two >> short at the moment. But we know that 1000Base-T and sync over power + the >> older APC's don't play nice anyway. >> >> On 11/21/2016 1:23 PM, Mathew Howard wrote: >> >> I've had a couple of them where I wasn't getting sync and couldn't figure >> out why... in one case (maybe both... I don't remember off hand), I was >> getting sync to an ePMP, but not to a PMP450i 900mhz AP that were both >> plugged into the same sync injector... I didn't really need sync on the >> 900mhz at the time, so I just switched it to generate it's own timing, and >> I haven't gotten around to trying to figure it out yet, but now I'm >> wondering if it would eventually come up if I left it alone. >> >> On Mon, Nov 21, 2016 at 12:45 PM, Seth Mattinen <[email protected]> >> wrote: >> >>> On 11/21/16 10:39, [email protected] wrote: >>> >>>> I had all the packet flux gear running for days, plugged in the 450i and >>>> started trying to figure out why it was not receiving sync. Half hour >>>> or more later it said it was OK, so the delay had to be Cambium, not >>>> Packetflux. >>>> >>> >>> >>> Check if the packetflux says it has fix and 1PPS is active on the binary >>> tab and that the used pulse count is increasing on the analog tab. >>> >>> ~Seth >>> >> >> >> >
