450i and 450m is supposed to get IEEE 1588v2 at some point. Doesn't
exist yet.
On 1/13/2017 9:21 PM, Chuck McCown wrote:
Isn’t all this new stuff sync over ethernet?
*From:* George Skorup
*Sent:* Friday, January 13, 2017 8:07 PM
*To:* [email protected]
*Subject:* Re: [AFMUG] CTM-2 Port Type G and 450i AP?
Yeahbut.. sync.
On 1/13/2017 8:51 PM, Chuck McCown wrote:
There is another method of powering these devices with 1.5 amps per
pair.
*From:* Sean Heskett
*Sent:* Friday, January 13, 2017 4:00 PM
*To:* [email protected]
*Subject:* Re: [AFMUG] CTM-2 Port Type G and 450i AP?
Yes type G will power a 450i and also a 450m however we've found that
a CTM2 has a hard time powering more than 1 or 2 450m's because of
the high watt useage of the 450m
-Sean
On Fri, Jan 13, 2017 at 1:08 PM Ken Hohhof <[email protected]> wrote:
Is anyone using a CTM-2 and power port sync with a 450i AP? I
was reading the CTM-2 firmware release notes, and it sounds like
they added a Port Type G that’s the same as Type B but with the
pin swap to eliminate the need for the external pin swapping
cables. (Basically undoing the pin swap that was introduced for
430 APs.)
I swapped out a bunch of 430 APs for 450i, using the Cambium pin
swapping cables. It would be nice to get rid of them and connect
direct, if I am reading this correctly.
