Need to reboot the CTM-2 and slave. They seem to randomly lock up like that every now and then.
- Sean On Fri, Jan 13, 2017 at 4:42 PM Ken Hohhof <[email protected]> wrote: > That’s good news, those dongles were messy and one more connection to > fail. > > > > Now if I could just figure out the communication problems I’ve started > having between a CTM-2 Master and Slave. Power readings of “NaN”, not able > to see/change slave port types, etc. > > > > > > *From:* Af [mailto:[email protected]] *On Behalf Of *Sean Heskett > *Sent:* Friday, January 13, 2017 5:01 PM > *To:* [email protected] > *Subject:* Re: [AFMUG] CTM-2 Port Type G and 450i AP? > > > > Yes type G will power a 450i and also a 450m however we've found that a > CTM2 has a hard time powering more than 1 or 2 450m's because of the high > watt useage of the 450m > > > > -Sean > > On Fri, Jan 13, 2017 at 1:08 PM Ken Hohhof <[email protected]> wrote: > > Is anyone using a CTM-2 and power port sync with a 450i AP? I was reading > the CTM-2 firmware release notes, and it sounds like they added a Port Type > G that’s the same as Type B but with the pin swap to eliminate the need for > the external pin swapping cables. (Basically undoing the pin swap that was > introduced for 430 APs.) > > > > I swapped out a bunch of 430 APs for 450i, using the Cambium pin swapping > cables. It would be nice to get rid of them and connect direct, if I am > reading this correctly. > >
