That’s good news, those dongles were messy and one more connection to fail.
Now if I could just figure out the communication problems I’ve started having between a CTM-2 Master and Slave. Power readings of “NaN”, not able to see/change slave port types, etc. From: Af [mailto:[email protected]] On Behalf Of Sean Heskett Sent: Friday, January 13, 2017 5:01 PM To: [email protected] Subject: Re: [AFMUG] CTM-2 Port Type G and 450i AP? Yes type G will power a 450i and also a 450m however we've found that a CTM2 has a hard time powering more than 1 or 2 450m's because of the high watt useage of the 450m -Sean On Fri, Jan 13, 2017 at 1:08 PM Ken Hohhof <[email protected] <mailto:[email protected]> > wrote: Is anyone using a CTM-2 and power port sync with a 450i AP? I was reading the CTM-2 firmware release notes, and it sounds like they added a Port Type G that’s the same as Type B but with the pin swap to eliminate the need for the external pin swapping cables. (Basically undoing the pin swap that was introduced for 430 APs.) I swapped out a bunch of 430 APs for 450i, using the Cambium pin swapping cables. It would be nice to get rid of them and connect direct, if I am reading this correctly.
