24v Power Injector has worked for ages here. CMM3 on four 2.4 and four 5 GHz.
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Mar 28, 2017 at 12:39 PM, Brandon Yuchasz <[email protected]> wrote: > Is anyone successfully running epmp 2.4 aps on packetflux as the primary > GPS for them? We have our sites with the onboard GPS puck as the primary > GPS and just recently started powering the newest sites with Packetflux in > order to provide a secondary GPS signal. At one site we has an AP that the > puck GPS was blocked during install and would not receive sync so we turned > on CMM3 and never were able to get GPS. Eventually we just did a climb and > moved the puck and its receiving GPS now. > > > > Last week when installing a new site I decided to try GPS through the > packetflux again and was not able to receive it. If I swap one of the > cables from a 450i into the same port on the packetflux we get GPS no > problem on the 450i AP but no joy on the epmp. I even went out and grabbed > an extra AP off the truck plugged it in with a 2 foot none shielded > Ethernet to the packetflux and still no GPS on CMM3. > > > > We are using power injector plus at the newest sites. No changes using > them out of the box on 48 volts and like I mentioned they provide GPS just > fine to the450i. > > > > > > So I am wondering if anyone is running this setup successfully of if we > are all just using the puck. > > > > Thanks, > > Brandon > > >
