Make sure you're on the later firmware versions. I think it was a 2.3.x bug where it would say no sync but it actually was.
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Mar 28, 2017 at 5:07 PM, Brandon Yuchasz <[email protected]> wrote: > I figured someone had to be doing it. Its not that big of deal until we > have a failure on one of the pucks in bad weather and then we will want to > drop back to the packetflux. I can’t figure out why the 450i works fine and > the epmp wont. Its seems like they should be the same. We started on 24 > volts went to 29.5 volts and then to 48 volts just to match the 450i stuff. > No difference. > > > > > > *From:* Af [mailto:[email protected]] *On Behalf Of *Josh Luthman > *Sent:* Tuesday, March 28, 2017 3:33 PM > *To:* [email protected] > *Subject:* Re: [AFMUG] 2.4 epmp and packetflux > > > > 24v Power Injector has worked for ages here. CMM3 on four 2.4 and four 5 > GHz. > > > > > Josh Luthman > Office: 937-552-2340 <(937)%20552-2340> > Direct: 937-552-2343 <(937)%20552-2343> > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > > > On Tue, Mar 28, 2017 at 12:39 PM, Brandon Yuchasz <[email protected]> > wrote: > > Is anyone successfully running epmp 2.4 aps on packetflux as the primary > GPS for them? We have our sites with the onboard GPS puck as the primary > GPS and just recently started powering the newest sites with Packetflux in > order to provide a secondary GPS signal. At one site we has an AP that the > puck GPS was blocked during install and would not receive sync so we turned > on CMM3 and never were able to get GPS. Eventually we just did a climb and > moved the puck and its receiving GPS now. > > > > Last week when installing a new site I decided to try GPS through the > packetflux again and was not able to receive it. If I swap one of the > cables from a 450i into the same port on the packetflux we get GPS no > problem on the 450i AP but no joy on the epmp. I even went out and grabbed > an extra AP off the truck plugged it in with a 2 foot none shielded > Ethernet to the packetflux and still no GPS on CMM3. > > > > We are using power injector plus at the newest sites. No changes using > them out of the box on 48 volts and like I mentioned they provide GPS just > fine to the450i. > > > > > > So I am wondering if anyone is running this setup successfully of if we > are all just using the puck. > > > > Thanks, > > Brandon > > > > >
