Yes, the silk screen was marked out with a sharpie for a short run of that rev due to my mistake. The label on the back should be accurate. I fixed it on the run of PCBS immediately following this. Sorry.
From: Jesse DuPont Sent: Tuesday, May 16, 2017 10:57 PM To: Animal Farm Subject: [AFMUG] GIGE-POE-APC Questions Chuck (or all), I've got a question on the GIGE-POE-APC (the concept of which, I love). I've got two pictures attached, appropriately labeled, of the jumper configurations. But, I'm confused. When I look at the drawing on the back, it says jumper to the left for positive and to the right for negative. Indeed, when I use an ohm meter, the left pin is 0 ohms to the positive lead on the phoenix connector and likewise, the right pin is 0 ohms to the neg on the phoenix connector. But, when I plug in a UBNT with the jumpers configured so 4/5 is pos and 7/8 is neg (as in the "didn't work..." image), my power supply goes into short circuit protection briefly and the GIGE-POE-APC smokes (once it lets the smoke out, the power supply is normal again). So I have to set the jumpers so 7/8 is pos and 4/5 is neg (as in the "works with ubnt" image). But I also see that the 4/5 and 7/8 labels seemed to be "sharpied" over; is this because those labels are swapped and the bottom pins are actually 4/5 (which would make sense)? Thanks! -- Jesse DuPont Network Architect email: [email protected] Celerity Networks LLC Celerity Broadband LLC Like us! facebook.com/celeritynetworksllc Like us! facebook.com/celeritybroadband
