Yeah, sorry. Fixed now. Brain Fart. From: George Skorup Sent: Tuesday, May 16, 2017 11:20 PM To: [email protected] Subject: Re: [AFMUG] GIGE-POE-APC Questions
I was confused at first too. It looks like Chuck may have got the 4/5 & 7/8 pair jumpers backwards, but fixed it on the label and simply blacked out the print on the board. The paper label on the back of the card is correct. I've used several in the past month on 2-pair and 4-pair powered radios without issue. On 5/16/2017 11:57 PM, Jesse DuPont wrote: Chuck (or all), I've got a question on the GIGE-POE-APC (the concept of which, I love). I've got two pictures attached, appropriately labeled, of the jumper configurations. But, I'm confused. When I look at the drawing on the back, it says jumper to the left for positive and to the right for negative. Indeed, when I use an ohm meter, the left pin is 0 ohms to the positive lead on the phoenix connector and likewise, the right pin is 0 ohms to the neg on the phoenix connector. But, when I plug in a UBNT with the jumpers configured so 4/5 is pos and 7/8 is neg (as in the "didn't work..." image), my power supply goes into short circuit protection briefly and the GIGE-POE-APC smokes (once it lets the smoke out, the power supply is normal again). So I have to set the jumpers so 7/8 is pos and 4/5 is neg (as in the "works with ubnt" image). But I also see that the 4/5 and 7/8 labels seemed to be "sharpied" over; is this because those labels are swapped and the bottom pins are actually 4/5 (which would make sense)? Thanks! -- Jesse DuPont Network Architect email: [email protected] Celerity Networks LLC Celerity Broadband LLC Like us! facebook.com/celeritynetworksllc Like us! facebook.com/celeritybroadband
