We scoured the vans and found a Parasitic to use, so its less of an emergency
From: Af [mailto:af-boun...@afmug.com] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 12:34 PM To: af <af@afmug.com> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device The rj45 has the equivalent of a timing port on pins 123 and 6. I don't have access to the full pinout but I'll see if I can pull it up when I get to more Internet On Jun 15, 2017 11:27 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: How would a SBJ Basic work? It only has a RJ45 connector…. With no timing ports, it can’t feed anything. Thought it was just a Sync Pipe basic replacement ? From: Af [mailto:af-boun...@afmug.com<mailto:af-boun...@afmug.com>] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 12:12 PM To: af <af@afmug.com<mailto:af@afmug.com>> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device A basic would work, along with about anything other than an aux or timing port version On Jun 15, 2017 11:01 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: We had moved away from SyncPipes for the most part, bought the SPJ Basics instead of pipes the past few times we needed that. From: Af [mailto:af-boun...@afmug.com<mailto:af-boun...@afmug.com>] On Behalf Of George Skorup Sent: Thursday, June 15, 2017 11:37 AM To: af@afmug.com<mailto:af@afmug.com> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device What else you got laying around? Deluxe pipe? Rev F/G/H will work fine with 12-56VDC. On 6/15/2017 10:34 AM, Paul McCall wrote: That’s what it appears. Am wondering if Forrest has a different voltage range for input since he built it himself Paul From: Af [mailto:af-boun...@afmug.com] On Behalf Of George Skorup Sent: Thursday, June 15, 2017 11:29 AM To: af@afmug.com<mailto:af@afmug.com> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device I'm about 63.48% sure that UGPS power is like 5-7VDC which is on one of the serial lines, IIRC. On 6/15/2017 10:15 AM, Paul McCall wrote: Soooo… can I power it off an S16 somehow, with the right cable? (24v?) Paul From: Af [mailto:af-boun...@afmug.com] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 11:04 AM To: af <af@afmug.com><mailto:af@afmug.com> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device OK found a short .pdf manual. Looks like the 100 series may not support this. The timing port model needs ugps power. On Jun 15, 2017 9:46 AM, "Forrest Christian (List Account)" <li...@packetflux.com<mailto:li...@packetflux.com>> wrote: Hmm. ... odd. I know it's in the 450, but I thought it was in the older radios too. I'm traveling, so can't look it up, but what does the uGPS manual say about FSK radios? On Jun 15, 2017 9:42 AM, "George Skorup" <george.sko...@cbcast.com<mailto:george.sko...@cbcast.com>> wrote: I don't have a single P10 or P11 FSK AP that has UGPS power control on the config page. Perhaps it's just always on? On 6/15/2017 9:35 AM, Forrest Christian (List Account) wrote: AFAIK All semi-modern fsk radios provide uGPS power. Just connect the radio and box together and turn on uGPS power in the radio. Use whatever cable cambium recommends for a uGPS probably just a 6p6c straight through cable, although it might make sense to skip the factory reset pin. On Jun 15, 2017 9:19 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: Hmmmm….. let me try again. I have a single FSK AP that is getting powered/ethernet successfully connected to a UBNT S16. I need to get sync to that radio. I want to power the SB Junior Timing Port Version by making a cable that I can connect to the S16 that will connect to one of the SBJTP timing ports to power it up. Unless that ALL FSKs timing ports actually would provide the power needed to power up the SBJTV ? with a “standard” cable whatever that means 😊 Paul From: Af [mailto:af-boun...@afmug.com<mailto:af-boun...@afmug.com>] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 10:08 AM To: af <af@afmug.com<mailto:af@afmug.com>> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device What type of fsk radio do you gave that doesn't do ups power? On Jun 15, 2017 9:04 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: Syncbox Junior Timing Port Version From: Af [mailto:af-boun...@afmug.com<mailto:af-boun...@afmug.com>] On Behalf Of Forrest Christian (List Account) Sent: Thursday, June 15, 2017 10:03 AM To: af <af@afmug.com<mailto:af@afmug.com>> Subject: Re: [AFMUG] Powering a Syncbox Junior without a uGPS type device Which syncbox? On Jun 15, 2017 8:51 AM, "Paul McCall" <pa...@pdmnet.net<mailto:pa...@pdmnet.net>> wrote: Guys, We need to providing timing on a single FSK AP and it is fed up the tower through fiber to a UBNT S16. (so its powering off the S16). I want to use one timing port to output timing to the FSK (as normal) and one port to receive power from the S16 and need to figure out the pinout (wiring diagram) to make that happen. Paul Paul McCall, President PDMNet, Inc. / Florida Broadband, Inc. 658 Old Dixie Highway Vero Beach, FL 32962 772-564-6800<tel:%28772%29%20564-6800> pa...@pdmnet.net<mailto:pa...@pdmnet.net> www.pdmnet.com<http://www.pdmnet.com> www.floridabroadband.com<http://www.floridabroadband.com>