OK found a short .pdf manual. Looks like the 100 series may not support this. The timing port model needs ugps power.
On Jun 15, 2017 9:46 AM, "Forrest Christian (List Account)" < [email protected]> wrote: > Hmm. ... odd. I know it's in the 450, but I thought it was in the older > radios too. > > I'm traveling, so can't look it up, but what does the uGPS manual say > about FSK radios? > > On Jun 15, 2017 9:42 AM, "George Skorup" <[email protected]> wrote: > >> I don't have a single P10 or P11 FSK AP that has UGPS power control on >> the config page. Perhaps it's just always on? >> >> On 6/15/2017 9:35 AM, Forrest Christian (List Account) wrote: >> >> AFAIK All semi-modern fsk radios provide uGPS power. Just connect the >> radio and box together and turn on uGPS power in the radio. Use whatever >> cable cambium recommends for a uGPS probably just a 6p6c straight through >> cable, although it might make sense to skip the factory reset pin. >> >> >> >> On Jun 15, 2017 9:19 AM, "Paul McCall" <[email protected]> wrote: >> >>> Hmmmm….. let me try again. >>> >>> >>> >>> I have a single FSK AP that is getting powered/ethernet successfully >>> connected to a UBNT S16. I need to get sync to that radio. I want to >>> power the SB Junior Timing Port Version by making a cable that I can >>> connect to the S16 that will connect to one of the SBJTP timing ports to >>> power it up. >>> >>> >>> >>> Unless that ALL FSKs timing ports actually would provide the power >>> needed to power up the SBJTV ? with a “standard” cable whatever that >>> means 😊 >>> >>> >>> >>> Paul >>> >>> >>> >>> *From:* Af [mailto:[email protected]] *On Behalf Of *Forrest >>> Christian (List Account) >>> *Sent:* Thursday, June 15, 2017 10:08 AM >>> *To:* af <[email protected]> >>> *Subject:* Re: [AFMUG] Powering a Syncbox Junior without a uGPS type >>> device >>> >>> >>> >>> What type of fsk radio do you gave that doesn't do ups power? >>> >>> >>> >>> On Jun 15, 2017 9:04 AM, "Paul McCall" <[email protected]> wrote: >>> >>> Syncbox Junior Timing Port Version >>> >>> >>> >>> *From:* Af [mailto:[email protected]] *On Behalf Of *Forrest >>> Christian (List Account) >>> *Sent:* Thursday, June 15, 2017 10:03 AM >>> *To:* af <[email protected]> >>> *Subject:* Re: [AFMUG] Powering a Syncbox Junior without a uGPS type >>> device >>> >>> >>> >>> Which syncbox? >>> >>> >>> >>> On Jun 15, 2017 8:51 AM, "Paul McCall" <[email protected]> wrote: >>> >>> Guys, >>> >>> >>> >>> We need to providing timing on a single FSK AP and it is fed up the >>> tower through fiber to a UBNT S16. (so its powering off the S16). I want >>> to use one timing port to output timing to the FSK (as normal) and one port >>> to receive power from the S16 and need to figure out the pinout (wiring >>> diagram) to make that happen. >>> >>> >>> >>> Paul >>> >>> >>> >>> Paul McCall, President >>> >>> PDMNet, Inc. / Florida Broadband, Inc. >>> >>> 658 Old Dixie Highway >>> >>> Vero Beach, FL 32962 >>> >>> 772-564-6800 <%28772%29%20564-6800> >>> >>> [email protected] >>> >>> www.pdmnet.com >>> >>> www.floridabroadband.com >>> >>> >>> >>> >>> >>> >>
