Okay Finally I am very very happy.. SO far I have only been able to test output (need to setup MIDI hardware again after a gig)
>From output using MusE CVS version. I have been able to send MIDI output to: individual ports multiple ports relaying different information... timecode... MIDI CLOCK, worked , MMC still to be tested I did not get a good SMPTE lock and the time display on the MTP-AV only aligned itself properly on stop.. (typical when a sync lock isn't established properly) both the PC and the MTP-AV were set to a SMTPE rate of 25 frames per second. (I remember we once tested this with a commandline app, I don't have them anymore .. do you still have them or links to them and we can check with that rather than MusE as SMPTE probably isn't fully implemented yet) One glitch I noticed was that the driver seemed to send the note information to all ports when the sequence I had only sent to one of the MTPAV ports... When I assigned a second to a different port it began behaving correctly. This is all however fantastic progress. cheers Allan On Fri, 2003-02-14 at 22:38, Takashi Iwai wrote: > Hi Allan, > > At 14 Feb 2003 14:26:19 +1100, > Allan Klinbail wrote: > > > > The device stopped seeing all messages when attempts at sending MIDI > > output to more than one port occured.(this is where the initialisation > > SYSEX probably comes into play) > > this problem may have been fixed (not perfect but works in most > cases) on cvs recently. if you have time, please try the cvs > version. > > > ciao, > > Takashi ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Alsa-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-devel
