> silent. Is this a known > problem of the I810 Chipset ???
No I use it normally here even with: 0-0/0: Analog Devices AD1881 Capabilities : -headphone out- DAC resolution : 16-bit ADC resolution : 16-bit 3D enhancement : Analog Devices Phat Stereo Current setup Mic gain : +0dB [+0dB] POP path : pre 3D Sim. stereo : off 3D enhancement : off Loudness : off Mono output : MIX Mic select : Mic1 ADC/DAC loopback : off Extended ID : codec=0 rev=0 DSA=0 VRA Extended status : VRA PCM front DAC : 44100Hz PCM ADC > Too silent means, I have to blow directly into the > mic to hear anything > ... normal speak, even cry load doesn't realy help > ... > [root@voyager cvoicecontrol]# cat /proc/asound/cards > 0 [card0 ]: ICH - Intel 82801BA-ICH2 > Intel 82801BA-ICH2 at 0xe000, > irq 10 > > > [root@voyager cvoicecontrol]# cat > /proc/asound/card0/ac97#0 > 0-0/0: Avance Logic ALC200/200P rev 0 > > Capabilities : -headphone out- > DAC resolution : 18-bit > ADC resolution : 18-bit > 3D enhancement : Realtek 3D Stereo Enhancement > > Current setup > Mic gain : +20dB [+20dB] > POP path : pre 3D > Sim. stereo : off > 3D enhancement : on > Loudness : off > Mono output : MIX > Mic select : Mic1 > ADC/DAC loopback : off > Extended ID : codec=0 rev=1 AMAP DSA=0 SPDIF > VRA > Extended status : SPCV SPDIF=3/4 VRA > PCM front DAC : 48000Hz > PCM ADC : 48000Hz > SPDIF Control : Consumer PCM Copyright > Category=0x2 Generation=1 > Rate=48kHz > May be my card is not totally like yours but I compile alsa --with-cards=intel8x0; not quite sure... How can you set the Mix gain? and some other setup like 3D enhance. etc..; Regards ===== Steve Kieu http://www.sold.com.au - SOLD.com.au - Find yourself a bargain! ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Gadgets, caffeine, t-shirts, fun stuff. http://thinkgeek.com/sf _______________________________________________ Alsa-user mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-user
