I'm pulling an old rocket out of mothballs to fly at NAR NSL, so I started by updating firmware. I updated my old TeleMetrum v1.1 to AltOS 1.87 and (ignoring the manual stating it wasn't necessary) figured I might as well upgrade my TeleDongle v0.2 while I had the casing off, so I flipped the umbilical and reset everything.
The first flash attempt failed. The second flash completed OK, and the light on the Dongle blinked, so I unplugged it. But after plugging it back in, the Dongle isn't recognized over USB, and I can't get it to re-flash. The error I get is: Cannot determine target device type > Image is fffe:000c > TeleDongle-v0.2 Flash anyways? If I say "OK," nothing happens in the UI, and the port gets stuck open until I restart things. This seems bad. Is there any way to recover from this state? If not, that's OK. This Dongle is 8+ years old, and I've been eyeing a TeleBT anyhow.... Casey
_______________________________________________ altusmetrum mailing list [email protected] http://lists.gag.com/mailman/listinfo/altusmetrum
