I was attempting to upgrade a TeleDongle 3.0 from 1.9 to 1.9.2 and I
managed to get it in a bad state. When I tried to flash the image under
Linux, I got an error (can't remember the message) and it then it
wouldn't show up as a USB device. Every time I try to flash the
TeleMetrum firmware, I get the same error message the first time, then
it usually works the next time I try it.
On the TeleDongle, I bridged pin 32 to ground and got the flash loader
to be recognized but I can't get it to flash an image. In Linux, it
just says "Opening Device" and in Windows, it does nothing after I
select the .ihx file - the dialog closes and goes back to the main UI.
I tried 1.9.1 and 1.9.4 on Windows and on Linux, 1.9.2 and 1.9.3.
Any ideas?
The reason I was trying to upgrade the TeleDongle firmware is that I've
had issues with losing the telemetry link after a while. The symptom is
that after a while, 5-30 min maybe, the TeleDongle will appear to stop
receiving data and the Age indicator will start counting up. The only
way to restore operation is to power cycle the TeleMetrum. Is this
known issue? I've had two TeleMetrum units and the same problem
occurred on both. Both devices are in the same room with plenty of
signal strength.
Thanks,
-Bob
_______________________________________________
altusmetrum mailing list
[email protected]
http://lists.gag.com/mailman/listinfo/altusmetrum
