Bdale,
My frequency counter only goes up to 100 MHz but I have a 3 GHz spectrum
analyzer and a 10 MHz GPSDO reference. Assuming I can get the RBW low
enough, do you think that would be sufficient?
I found this post in the archives:
https://lists.gag.com/pipermail/altusmetrum/2018-August/001364.html
I was able to get into the board with a terminal so assuming these
instructions are still valid, I can try that.
-Bob
On 9/24/20 12:54 PM, Bdale Garbee wrote:
Robert Watzlavick <[email protected]> writes:
Can you provide the radio calibration value for TeleDongle S/N 5177?
Unfortunately, the cal value for 5177 seems to have been lost in a hard
drive failure here. If you have access to a frequency counter, I can
talk you through re-determining the value. If not, I'll be happy to
issue you an RMA and re-cal the unit for you at no charge.
Keith - I'm very certain the TeleMetrum is not still beeping when the
problem occurs now that I think about it. A power cycle fixes it. Are
there any timeouts that make it shut down after a while on the ground?
No, a board in either idle or pad mode will continue operating until the
battery is discharged.
Bdale
_______________________________________________
altusmetrum mailing list
[email protected]
http://lists.gag.com/mailman/listinfo/altusmetrum
