There is a setting in AA Settings that prevents taking a position if your 
volume exceeds a certain threshold of the bar's volume. If you were right on 
the cusp of that threshold with a lessor commission, perhaps with the greater 
commission (fewere units, same total price)  you squeeked under the limit and 
took the trade.

Best way to compare is to set AA Settings reporting to detailed, then run under 
both scenarios and compare the output. You will see why each signal was 
accepted/rejected.

Mike

--- In [email protected], Potato Soup <potatoso...@...> wrote:
>
> Well I have my account balance at $350k and I'm trading no more than $30k max 
> in positions, how on earth could it skip a trade with that? I am using 2:1 
> margin but with that ratio of capital to exposure it should be impossible to 
> have an effect. What else could be the reason?
> 
> Also I have no changes or uses of BuyPrice/SellPrice and I have trade delays 
> set to 0 for all four types of orders.
> 
> Given all that, what other reasons could cause this behavior? 
> 
> Thanks for your help, as always.
> 
> 
> 
> 
> ________________________________
> From: Mike <sfclimb...@...>
> To: [email protected]
> Sent: Tue, December 29, 2009 11:52:48 PM
> Subject: [amibroker] Re: Backtester is opening positions at bar *low*, not at 
> *close*
> 
> 1. Changing *any* setting related to pricing can affect your trades. All it 
> takes is one penny too little in your account to prevent the taking of a 
> trade, which in turn would mean having more funds available for the next 
> opportunities (i.e. able to take other trades) that would not have been there 
> if the original trade were able to be taken at a penny less.
> 
> 2. If you've confirmed that the AA Settings window has the trade price marked 
> as Close, and that you have not put in an override in your AFL code (look for 
> BuyPrice, SellPrice and Signal alteration in custom backtester code), then 
> check too that you have not set any trade delays. A trade delay will cause 
> the next bar(s) price to be used which will likely be different than that of 
> the bar on which the signal was triggered.
> 
> Mike
> 
> --- In [email protected], Potato Soup <potatosoupz@> wrote:
> >
> > Now this is really weird. I just ran the backtester again and also noticed 
> > that the trade opening and closing is happening on the LOW of bars that 
> > have signals, not on the CLOSE, as I've defined it in the settings for the 
> > backtester. I have it set to execute trades on Close for all four 
> > parameters (buy,sell,short,cover).
> > 
> > Why would this be happening? I haven't overriden it in my AFL either. It's 
> > completely throwing off the results of the test. Obviously there's no way 
> > to know what the low of a bar would be until the bar is complete, and in 
> > the past.
> >
> 
> 
> 
> 
> ------------------------------------
> 
> **** IMPORTANT PLEASE READ ****
> This group is for the discussion between users only.
> This is *NOT* technical support channel.
> 
> TO GET TECHNICAL SUPPORT send an e-mail directly to 
> SUPPORT {at} amibroker.com
> 
> TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
> http://www.amibroker.com/feedback/
> (submissions sent via other channels won't be considered)
> 
> For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
> http://www.amibroker.com/devlog/
> 
> Yahoo! Groups Links
>


Reply via email to