Hello,
Such behaviour can only have one explanation, you
are overriding BuyPrice/ShortPrice with prices lower than Low.
It can happen for example if you are referring to previous day prices
(using Ref())
that can easily be lower than todays.
If you can not spot the error in formula send it to support and Marcin
will tell you where
error is.
Best regards,
Tomasz Janeczko
amibroker.com
On 2009-12-30 13:12, Potato Soup wrote:
I have that value set to 0% in the Portfolio tab. Has been that way
for some tmie. I will run the test with detailed reports. Thanks.
------------------------------------------------------------------------
*From:* Mike <[email protected]>
*To:* [email protected]
*Sent:* Wed, December 30, 2009 1:32:53 AM
*Subject:* [amibroker] Re: Backtester is opening positions at bar
*low*, not at *close*
There is a setting in AA Settings that prevents taking a position if
your volume exceeds a certain threshold of the bar's volume. If you
were right on the cusp of that threshold with a lessor commission,
perhaps with the greater commission (fewere units, same total price)
you squeeked under the limit and took the trade.
Best way to compare is to set AA Settings reporting to detailed, then
run under both scenarios and compare the output. You will see why each
signal was accepted/rejected.
Mike
--- In [email protected] <mailto:[email protected]>,
Potato Soup <potatoso...@...> wrote:
>
> Well I have my account balance at $350k and I'm trading no more than
$30k max in positions, how on earth could it skip a trade with that? I
am using 2:1 margin but with that ratio of capital to exposure it
should be impossible to have an effect. What else could be the reason?
>
> Also I have no changes or uses of BuyPrice/SellPrice and I have
trade delays set to 0 for all four types of orders.
>
> Given all that, what other reasons could cause this behavior?
>
> Thanks for your help, as always.
>
>
>
>
> ________________________________
> From: Mike <sfclimb...@...>
> To: [email protected] <mailto:[email protected]>
> Sent: Tue, December 29, 2009 11:52:48 PM
> Subject: [amibroker] Re: Backtester is opening positions at bar
*low*, not at *close*
>
> 1. Changing *any* setting related to pricing can affect your trades.
All it takes is one penny too little in your account to prevent the
taking of a trade, which in turn would mean having more funds
available for the next opportunities (i.e. able to take other trades)
that would not have been there if the original trade were able to be
taken at a penny less.
>
> 2. If you've confirmed that the AA Settings window has the trade
price marked as Close, and that you have not put in an override in
your AFL code (look for BuyPrice, SellPrice and Signal alteration in
custom backtester code), then check too that you have not set any
trade delays. A trade delay will cause the next bar(s) price to be
used which will likely be different than that of the bar on which the
signal was triggered.
>
> Mike
>
> --- In [email protected] <mailto:[email protected]>,
Potato Soup <potatosoupz@> wrote:
> >
> > Now this is really weird. I just ran the backtester again and also
noticed that the trade opening and closing is happening on the LOW of
bars that have signals, not on the CLOSE, as I've defined it in the
settings for the backtester. I have it set to execute trades on Close
for all four parameters (buy,sell,short,cover).
> >
> > Why would this be happening? I haven't overriden it in my AFL
either. It's completely throwing off the results of the test.
Obviously there's no way to know what the low of a bar would be until
the bar is complete, and in the past.
> >
>
>
>
>
> ------------------------------------
>
> **** IMPORTANT PLEASE READ ****
> This group is for the discussion between users only.
> This is *NOT* technical support channel.
>
> TO GET TECHNICAL SUPPORT send an e-mail directly to
> SUPPORT {at} amibroker.com <http://amibroker.com>
>
> TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
> http://www.amibroker.com/feedback/
> (submissions sent via other channels won't be considered)
>
> For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
> http://www.amibroker.com/devlog/
>
> Yahoo! Groups Links
>
------------------------------------
**** IMPORTANT PLEASE READ ****
This group is for the discussion between users only.
This is *NOT* technical support channel.
TO GET TECHNICAL SUPPORT send an e-mail directly to
SUPPORT {at} amibroker.com
TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
http://www.amibroker.com/feedback/
(submissions sent via other channels won't be considered)
For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
http://www.amibroker.com/devlog/
Yahoo! Groups Links
[email protected]
<mailto:[email protected]>