Csaba,
In ARACHNE.CFG try changing "IP_Address PPP" to "IP_Address %MYIP%". When I
installed 1.60b1, I, too, failed to connect although I was using the same
computer and ISP that I had been using all along. Just making this one
change resulted in connecting immediately.
Hope this helps.
Roger Turk
Tucson, Arizona USA
Csaba wrote:
>>Hi Guenter,
> You use a 'new' motherboard with 686 CPU and a lot of MHz. If your seriell
> adapter card (if not onboard) is an old one, the 'Speed 115200' may be
> too fast, only for testing try 9600 or 19200.
The situation is the same. Moreover I tried my old external modem (14.4k).
I got the same result.
> After your manual authentication, your ISP sends you something
> like 'start your PPP protocol' have you pressed 'F7' or 'Ctrl-P' ?
Yes, I get a short message (my IP address, mru=1500...etc.).
And when the "exotic characters" receive, I press <F7>.
> Do you see a short DOS- message that the packet driver is
> installed/ not installed ?
Yes, I get it. Moreover I see some modem-activity (RD and SD leds),
but after 20 secs the line is cut off, and the ppp_err.ah appears.
Kind regards,
Csaba<<
