Hi Harry,
Below is the arachne.cfg that I use to connect
to a BBS/PPP type ISP. After it dials and connects, it then
asks you to press F7 to load packet driver. If I wait too long
before I press F7, then I have to enter my name & password
manually.
Eric
Harry Murphy wrote:
>
>Arachne Wizards:
>
> I'm still having trouble linking to my ISP and would
>appreciate any help you can give me. As I said in an earlier
>message, when I dial my ISP, I find myself in text mode, as if I
>were trying to access my ISP's BBS system, rather than his Web
>site.
>---<snip>---<
> I'm attaching my ARACHNE.CFG file (with my password changed)
>to this message. Any suggestions would be very greatly
>appreciated. I really want to get Arachne up and running before
>my ISP yanks his BBS service.
>
>Best Wishes from
>Sunny (and Cold!) New Mexico,
>
>Harry M. Murphy
>
**************************************
File 1: uses F7 to log on:
;This is ARACHNE.CFG for Arachne version 1.6+
;If you want to use Arachne on PC with CPU 486+ you should start here.
;(tested on AMD K5/133). This profile is slightly less video-intensive.
;This configuration file can be completely controled from Arachne setup.
;Run "setup" if you are not sure what to change in configuration file.
[profile]
Profile 486PC.ACF
Connection @epppd.exe>>PPP.LOG
Hangup @termin.com 0x60>NUL
;Connection @cmd ... command cmd will estabilish connection
;Connection READY ... connection is permanent, packet driver in AUTOEXEC...
;Connection NUL ... do not start TCP/IP (run "arachne -c" to force this)
[dialer]
DialPage file:home.bmp
Dialer @MINITERM.EXE>PPP.LOG
TerminalWindow @MINITERM.EXE
UseTerminal Yes
Port 1 < insert proper data for your system
Irq 4 < insert proper data for your system
Base 0x3f8 < insert proper data for your system
Mode 8N1
Speed 38400
InitString +++AT&F < insert proper data for your system
DialString ATDT
PhoneNumber 1-248-553-7653 < insert proper data for your system
Autologin No
WaitFor1 name:
Response1 \u
WaitFor2 sword:
Response2 \p
;WaitFor3 < note ";" to comment out this line
;Response3 < note ";" to comment out this line
PPPusername emersone
PPPpassword eric1360
;Port values: 0=non-standard serial (COM) port, 1-4 standard ports
;Base values: 0x??? (eg. 0x3e8) - Base and Irq are used for "Port 0"
;Mode values: databits/parity/stopbits (eg. 8N1)
[tcp/ip]
IP_Address PPP
IP_Grab IP address set to
NameServer 209.104.141.196 < insert proper data for your system
AltNameServer 209.104.131.25 < insert proper data for your system
Gateway 0.0.0.0
AltGateway 0.0.0.0
Netmask 0.0.0.0
TCPconfig PPPTCP.CFG
***********************************************
--
__________
| Ayrx |__\_ Eric S. Emerson
| E-male:~_: ! [EMAIL PROTECTED]
`~(*)~~~~(*)~' `````````````````````````
