Hi. > Here is a list of things to check: let's go through it.
> 1. In alsamixer, make sure that you have: some things I found - some not > 1.1. 3D control center in level 0 > 1.2. 3D control depth in level 0 > 1.3. 3D control switch muted done > 1.5. Surround muted > 1.6. Surround down mix muted > 1.7. Surround jack mode shared (don't know what this means :-) > 1.8. Center muted > 1.9. Center/LFE Down Mix muted not found > 1.10. Mic muted (if you want to hear what is received in mic, you > can set this in a level that you desire) > 1.11. Mic Boost muted (same comments as above) > 1.12. Mic select as you choose done > 1.13. IEC958 muted > 1.14. IEC958 playback AC97-SPSA doesn't matter done > 1.15. Analog to IEC958 Output muted not found > 1.16. Channel mode 2ch > 1.17. Duplicate front muted > 1.18. Exchange center/LFE muted > 1.19. External amplifier muted > 1.20. Swap surround slot muted not found > 2. You don't need to load any modules in MODULES clause of rc.conf. > Udev is able to guess the right ones. Should I have it empty? MODULES=(intel-agp uhci_hcd eepro100 ipw2100 ohci1394 yenta_socket speedstep-centrino cpufreq_powersave cpufreq_userspace freq_table fuse) > 3. You need to put hal and alsa in the DAEMONS clause of rc.conf. Hal > must be before alsa. done DAEMONS=(syslog-ng klogd @network @laptop_mode !fam @hal !acpid @cpudyn @uptimed @alsa) > 4. /etc/modprobe.conf must not have any references to the snd-* > modules. They are not needed anymore, because udev does its job. # /etc/modprobe.conf (for v2.6 kernels) # # --- BEGIN: Generated by ALSACONF, do not edit. --- # --- ALSACONF version 1.0.10 --- #alias snd-card-0 snd-intel8x0 #alias sound-slot-0 snd-intel8x0 # --- END: Generated by ALSACONF, do not edit. --- #alias eth1 ipw2100 I #ed lines 5,6 and 9. [don't know why I had line 9 in?] -- Gruß, Johannes http://www.hehejo.de _______________________________________________ arch mailing list [email protected] http://www.archlinux.org/mailman/listinfo/arch
