THat's not it. in zapata.conf you *also* need to have signalling=pri_cpe or pri_net
Martin On Mon, 23 Jun 2003, Michael Bielicki wrote: > On Monday 23 June 2003 2:58 pm, Anton Yurchenko wrote: > > Hello, > > > > I have an E100P, and in the zaptel.conf I have: > > > > span=1,1,0,ccs,hdb4,crc4,yellow > > fxsks=1-10 > delete the fxsks line and put: > bchan=1-15,17-31 > dchan=16 > > > > the light on the card is green( BTW what do all those states of the card > > that zttool reports YELLO, RED, BLUE ..., is there a doc for zttool?, or > > for the card?) > > > > in the asterisks` zapata.conf I have: > > > > [channels] > > context=default > > switchtype=euroisdn > > signalling=fxs_ks > > usecallerid=yes > > hidecallerid=no > > callwaiting=yes > > callwaitingcallerid=yes > > threewaycalling=yes > > transfer=yes > > cancallforward=yes > > callreturn=yes > > echocancel=yes > > echocancelwhenbridged=yes > > rxgain=0.0 > > txgain=0.0 > > group=1 > > callgroup=1 > > pickupgroup=1 > > > > immediate=no > > callerid="line1"< 238-20-31> > > channel => 1 > > callerid="line2"< 238-20-31> > > channel => 2 > > > > > > but Asterisk on startup reports that: > > > > WARNING[13326]: File chan_zap.c, Line 4173 (ss_thread): CallerID returned > > with rror on channel 'Zap/1-1' > > WARNING[14351]: File chan_zap.c, Line 4173 (ss_thread): CallerID returned > > with rror on channel 'Zap/2-1' > > > > > > and when I call the number that is supposed to terminate there I get > > busy signal. > > also in the zttool I see strange thing, in the bottom portion where > > there are RxA, RxB .... the 1111111 ( ones) sometimes change into > > 000000, they go from up to down and if I enable all the channels then > > firs on the first column then on the second column, in the bottom half > > of the screen. > > > > while if I plug the same E1 into Cisco AS5300, whit this config( just > > exepts): > > > > isdn switch-type primary-net5 > > > > controller e1 ... > > clock source line primary > > pri-group timeslots 1-31 > > ... > > > > interface Serial0:15 > > isdn switch-type primary-net5 > > isdn incoming-voice modem 64 > > > > Framing is CRC4, Line Code is HDB3, Clock Source is Line ... > > > > > > on Cisco the swithtype is primary-net5 ( my guess its euroisdn ? ) > > > > anybody could guess what is the problem? > > > > The admin that runs the Cisco says that signalyng should be PRI , and there > > is an option for pri signaling in zapata.conf, but the zaptel,conf doesnt > > have it and so I`d get up with a mismatch, and zasterisk would not start. > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
