It can be a bad module. Contact [EMAIL PROTECTED] regards Martin
On Wed, 6 Aug 2003, Eduardo Goncalves wrote: > Martin, > > With KFLAGS+=-DNO_CALIBRATION uncommented, the module loads fine. Without the > calibration. > But I have no dial-tone on port 4. All the three other ports works fine. > Could it be a hardware problem? > > Thanks in Advance > Eduardo > > On Fri, 1 Aug 2003 16:11:12 -0500 (CDT) > Martin Pycko <[EMAIL PROTECTED]> wrote: > > > Try to uncomment in zaptel/Makefile > > KFLAGS+=-DNO_CALIBRATION > > > > and "make clean install" > > > > that should help > > > > Martin > > > > On Fri, 1 Aug 2003, Eduardo Goncalves wrote: > > > > > On Fri, 1 Aug 2003 15:34:23 -0500 (CDT) > > > Martin Pycko <[EMAIL PROTECTED]> wrote: > > > > > > > What does 'dmesg' say ? > > > > > > > > > > > > > CSLIP: code copyright 1989 Regents of the University of California > > > PPP generic driver version 2.4.1 > > > Zapata Telephony Interface Registered on major 196 > > > Freshmaker version: 62 > > > Freshmaker passed register test > > > Module 0: Initialized > > > Module 1: Initialized > > > Module 2: Initialized > > > Timeout waiting for calibration of module 3 > > > ProSlic died on Calibration. > > > Module 3: Not installed > > > Found a Wildcard FXS: Wildcard S400P Prototype (4 modules) > > > > > > and then the errors that I mentioned. > > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
