Try adding ",crc4" to the end of the span definition. Mark
On Fri, 12 Sep 2003, Alastair Maw wrote: > We've changed E1 providers and I'm trying to reconfigure an E400P to > make it work with the new lines. They're supposedly "standard" EuroISDN > lines (in the UK). I'm initially just trying to get a single line up. > > I have the following in /etc/zaptel.conf: > > span=1,0,0,ccs,hdb3 > bchan=1-15 > dchan=16 > bchan=17-31 > loadzone=uk > defaultzone=uk > > The LED on the back of the card shows red/green simultaneously when you > ztcfg it. > > Asterisk itself spews messages to the console like so: > > == D-Channel on span 1 up > == D-Channel on span 1 up > == D-Channel on span 1 up > == D-Channel on span 1 up > == D-Channel on span 1 down > == D-Channel on span 1 up > == D-Channel on span 1 up > == D-Channel on span 1 up > == D-Channel on span 1 up > == D-Channel on span 1 down > > (Always four ups and then a down a bit later, followed by a pause, then > the same again.) > > Changing span=1,0,0,css,hdb3 to use crc4 causes Asterisk to throw lots > of yellow alarms when it starts. Putting a 1 in the timing field makes > no discernable difference. > > The guy who tested the lines isn't very clueful - he just plugs in his > gear and puts a tick in the box, but he's pretty sure it uses hdb3 > coding. CAS framing makes the LED go RED. > > Anyone give me a clue here? > > -- > Alastair Maw <[EMAIL PROTECTED]> > MX Telecom - Systems Analyst > http://www.mxtelecom.com > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
