It's supported on my PRI interface:
controller T1 1/0
framing esf
linecode b8zs
pri-group timeslots 1-24
interface Serial1/0:23
no ip address
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable
dial-peer voice 200 pots
description Match all inbound POTS calls
destination-pattern .T
direct-inward-dial
port 1/0:23
forward-digits all
Tim Pozar wrote:
Greg Oliver wrote:
Add direct-inward-dial to your dial peer and it should work fine.
That command is only supported for POTS interfaces. :-( Not PRIs (aka
ISDN in cisco parlance).
Tim
------------------------------------------------------------------------
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
