Hello list,
After upgrading from BRIstuff 1y-b to 1y-e my ISDN card is suddently
detected as 2 ports instead of 4.
I still load the driver as "modprobe qozap ports=12" as I've always
done. But now it only sees 2 ports.
Output of "lspci -vvv"
------ cut --------
02:01.0 ISDN controller: Cologne Chip Designs GmbH ISDN network
Controller [HFC-4S] (rev 01)
Subsystem: Cologne Chip Designs GmbH Unknown device b560
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 22
Region 0: I/O ports at ddb8 [size=8]
Region 1: Memory at fcefa000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
------ cut --------
Anyone has any ideas?
--
Best regards,
Henrik Woffinden
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
