The *BEST* solution would be to have Verizon switch you over to a PRI. On Wed, Apr 29, 2009 at 17:29, Daniel Hazelbaker <[email protected]> wrote: > Okay, I can't find what might be causing this. Here is what I got: > > Asterisk server hooked up to a digital T1 line (full 24-channel) via a > Digium card. > Verizon has turned on caller ID on the first line (I can guarantee it > is on as I can hear the FSK tones on this line but not the others). > Using zttool an ZapScan() I have determined the following: > > 1) The RxB/RxD bits toggle from 1 to 0 signaling a ring. > 2) A short time later, via ZapScan() I can hear the FSK tone. > 3) About the same time I hear the FSK tone I see the "Starting simple > switch" line in the Asterisk console. > 4) Next I see the second ring trigger in zttool and then Asterisk say > "ss_thread: Got event 18 (Ring Begin)". > > Caller ID never shows up. I have tried cranking the rxgain up > thinking maybe it was too quiet for Asterisk to detect but that did > not help. My caller id settings in zapata.conf are: > > usecallerid=yes > callerid=asreceived > cidsignalling=bell > cidstart=ring > signalling=fxs_ks > > Is there any existing debug options I can turn on, or do I need to add > some to try and figure out what is going on; or does somebody have an > instant answer for me? > > Thanks, > Daniel > > _______________________________________________ > -- Bandwidth and Colocation Provided by http://www.api-digital.com -- > > asterisk-users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users >
_______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
