| Steven Critchfield <[EMAIL PROTECTED]>
Sent by: [EMAIL PROTECTED] 03/03/2004 04:06 PM
|
To: [EMAIL PROTECTED] cc: Subject: Re: [Asterisk-Users] wct1xxp module and the T100P |
On Wed, 2004-03-03 at 17:01, [EMAIL PROTECTED] wrote:
> I'm having trouble turning up a PRI to a T100P. I've read on the
> Digium FAQ's that once the wct1xxp module is loaded correctly, the LED
> on the T100P will flash red. I believe I've loaded the module
> correctly because both wct1xxp and zaptel are listed when I do the
> "lsmod" command. The LED on the card does not flash on and off. Does
> anyone have any recommendations on what I could be doing wrong?
Could be wrong or bad cable, could be incorrect configuration, could be
no service on the line yet.
Must provide data to get information.
--
Steven Critchfield <[EMAIL PROTECTED]>
__________________________________________________________________
I know the PRI is good to the RJ-45 right before it goes into the T100P; I've made calls on it with our T-Berd. So I'm sure the cable is ok and there is service on the line.
I haven't run Asterisk yet; shouldn't the card look "alive" once its driver module is loaded?
Thanks!
chris
